Gergely T. Zimanyi

Gergely T. Zimanyi

Auto-generated profile, based on publicly available information

Gergely T. Zimanyi

Univ. of California, Davis, CA (United States)

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 March 2016 in AIP Advances
Verified
Journal Article
Open access
PDF file
MIM. Ito
M. Ito
MYM. Yano
M. Yano
NSN. Sakuma
N. Sakuma
HKH. Kishimoto
H. Kishimoto
AMA. Manabe
A. Manabe
GZG. T. Zimanyi
G. T. Zimanyi
Ce-based R2Fe14B (R= rare-earth) nano-structured permanent magnets consisting of (Ce,Nd)2Fe14B core-shell grains separated by a non-magnetic grain boundary phase, in which the relative amount of Nd to Ce is higher in the shell of the magnetic grain than in its core, were fabricated by Nd-Cu infiltration into (Ce,Nd)2Fe14B hot-deformed magnets. The coercivity values of infiltrated core-shell structured magnets are superior to those of as-hot-deformed magnets with the same overall Nd content. This is attributed to the higher value of magnetocrystalline anisotropy of the shell phase in the core-shell structured infiltrated magnets compared to the homogeneous R2Fe14B grains of the as-hot-deformed magnets, and to magnetic isolation of R2Fe14B grains by the infiltrated grain boundary phase. First order reversal curve (FORC) diagrams suggest that the higher anisotropy shell suppresses initial magnetization reversal at the edges and corners of the R2Fe14B grains.

21 November 2013 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
ICI. Carbone
I. Carbone
SCS. A. Carter
S. A. Carter
GZG. T. Zimanyi
G. T. Zimanyi
A Monte Carlo hopping model was developed to simulate electron and hole transport in nanocrystalline PbSe films. Transport is carried out as a series of thermally activated hopping events between neighboring sites on a cubic lattice. Each site, representing an individual nanocrystal, is assigned a size-dependent electronic structure, and the effects of particle size, charging, interparticle coupling, and energetic disorder on electron and hole mobilities were investigated. Results of simulated field-effect measurements confirm that electron mobilities and conductivities at constant carrier densities increase with particle diameter by an order of magnitude up to 5 nm and begin to decrease above 6 nm. We find that as particle size increases, fewer hops are required to traverse the same distance and that site energy disorder significantly inhibits transport in films composed of smaller nanoparticles. The dip in mobilities and conductivities at larger particle sizes can be explained by a decrease in tunneling amplitudes and by charging penalties that are incurred more frequently when carriers are confined to fewer, larger nanoparticles. Using a nearly identical set of parameter values as the electron simulations, hole mobility simulations confirm measurements that increase monotonically with particle size over two orders of magnitude.

8 March 2022 in npj Computational Materials
Verified
Journal Article
Open access
PDF file
HOHarald Oezelt
Harald Oezelt
LQLuman Qu
Luman Qu
AKAlexander Kovacs
Alexander Kovacs
JFJohann Fischbacher
Johann Fischbacher
MGMarkus Gusenbauer
Markus Gusenbauer
TSThomas Schrefl
Thomas Schrefl
In this paper, we address the problem that standard stochastic Landau-Lifshitz-Gilbert (sLLG) simulations typically produce results that show unphysical mesh-size dependence. The root cause of this problem is that the effects of spin-wave fluctuations are ignored in sLLG. We propose to represent the effect of these fluctuations by a full-spin-wave-scaled stochastic LLG, or FUSSS LLG method. In FUSSS LLG, the intrinsic parameters of the sLLG simulations are first scaled by scaling factors that integrate out the spin-wave fluctuations up to the mesh size, and the sLLG simulation is then performed with these scaled parameters. We developed FUSSS LLG by studying the Ferromagnetic Resonance (FMR) in Nd2Fe14B cubes. The nominal scaling greatly reduced the mesh size dependence relative to sLLG. We then performed three tests and validations of our FUSSS LLG with this modified scaling. (1) We studied the same FMR but with magnetostatic fields included. (2) We simulated the total magnetization of the Nd2Fe14B cube. (3) We studied the effective, temperature- and sweeping rate-dependent coercive field of the cubes. In all three cases, we found that FUSSS LLG delivered essentially mesh-size-independent results, which tracked the theoretical expectations better than unscaled sLLG. Motivated by these successful validations, we propose that FUSSS LLG provides marked, qualitative progress towards accurate, high precision modeling of micromagnetics in hard, permanent magnets.

1 February 2020 in AIP Advances
Verified
Journal Article
Open access
PDF file
CSC. Skelland
C. Skelland
SWS. C. Westmoreland
S. C. Westmoreland
TOT. Ostler
T. Ostler
RER. F. L. Evans
R. F. L. Evans
RCR. W. Chantrell
R. W. Chantrell
GHGino Hrkac
Gino Hrkac
We investigated, using molecular dynamics, how pressure affects the melting point of the recently theorised and epitaxially grown structure NdFe12. We modified Morse potentials using experimental constants and a genetic algorithm code, before running two-phase solid-liquid coexistence simulations of NdFe12 at various temperatures and pressures. The refitting of the Morse potentials allowed us to significantly improve the accuracy in predicting the melting temperature of the constituent elements.

20 June 2021
Verified
Conference Paper
Closed access
DUDavis G. Unruh
Davis G. Unruh
CHChase M. Hansen
Chase M. Hansen
RMReza Vatan Meidanshahi
Reza Vatan Meidanshahi
SGStephen Goodnick
Stephen Goodnick
GZGergely T. Zimanyi
Gergely T. Zimanyi
a-Si/c-Si heterojunction solar cells hold the efficiency world record around 27%, yet their market penetration is delayed. One concern is the presence of an amorphous Si layer that some suspect may speed up the degradation of their performance. To address this concern, we developed the SolDeg structural simulation platform that is capable of capturing extremely slow degradation processes in a-Si. SolDeg integrates molecular dynamics methods that optimize the Si structure with femtosecond time steps, with the nudged elastic band method that captures the defect generation on time scales extending to gigaseconds. In this paper we report SolDeg simulations for Si-only heterojunctions. The SolDeg platform enabled us to determine the defect generation rate to be in the 15-20%/year range, translating into a 1-1.5%/year Voc degradation rate. These results establish that SolDeg can be a uniquely useful platform to describe degradation processes with an eye on finding strategies to mitigate the performance degradation of these promising heterojunction cells.