İlyas Hacısalihoğlu

İlyas Hacısalihoğlu

Auto-generated profile, based on publicly available information

İlyas Hacısalihoğlu

Department of Mechanical Engineering, Erzurum Technical University, Erzurum, Turkey

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 May 2021 in Journal of Materials Engineering and Performance
Verified
Journal Article
Closed access
PDF file
İHİlyas Hacisalihoğlu
İlyas Hacisalihoğlu
FYFatih Yildiz
Fatih Yildiz
AÇAyhan Çelik
Ayhan Çelik

1 February 2021 in Surfaces and Interfaces
Verified
Journal Article
Closed access
İHİlyas Hacısalihoğlu
İlyas Hacısalihoğlu
GKGÜRKAN KAYA
GÜRKAN KAYA
TET. Oğuzhan Ergüder
T. Oğuzhan Ergüder
Emre MandevEmre Mandev
Emre Mandev
EMEyüphan Manay
Eyüphan Manay
FYFatih Yıldız
Fatih Yıldız

1 August 2023 in 3D Printing and Additive Manufacturing
Verified
Journal Article
Closed access
GKGÜRKAN KAYA
GÜRKAN KAYA
TETevfik Oğuzhan Ergüder
Tevfik Oğuzhan Ergüder
İHİlyas Hacısalihoğlu
İlyas Hacısalihoğlu
Emre MandevEmre Mandev
Emre Mandev
EMEyüphan Manay
Eyüphan Manay
FYFatih Yıldız
Fatih Yıldız
In this study, it was targeted to enhance the tribological and thermal properties of Ti6Al4V alloys, which were manufactured with three different build orientations and hatch spacing by using the selective laser melting (SLM) method and a traditional method (casting). In addition, the surfaces of the samples produced by these two methods were coated with the TiAlN thin film by using the cathodic arc physical vapor deposition (CAPVD) method. After the experimental investigations, the lowest wear rate was obtained for the 60–90° sample, and the highest microhardness value was measured as ∼1070 HV 0.1 for the 90–45° sample. It was specified that the wear rate rose as the hatch spacing increased among the same build orientation Ti6Al4V alloys produced by SLM method. According to thermal analysis results, among the same hatch spacing values, it was determined that as the build orientation value increased, the specific heat capacity and thermal conductivity values decreased. Among the coated samples, the highest thermal conductivity and specific heat capacity values were obtained for casting samples as 5.63 (W/m·K) and 560.4 (J/kg·K), respectively.