3 May 2011 in International Journal of Quantum Chemistry
14 November 2017 in The Journal of Chemical Physics
A new large-scale parallel multiconfigurational self-consistent field (MCSCF) implementation in the open-source NWChem computational chemistry code is presented. The generalized active space approach is used to partition large configuration interaction (CI) vectors and generate a sufficient number of batches that can be distributed to the available cores. Massively parallel CI calculations with large active spaces can be performed. The new parallel MCSCF implementation is tested for the chromium trimer and for an active space of 20 electrons in 20 orbitals, which can now routinely be performed. Unprecedented CI calculations with an active space of 22 electrons in 22 orbitals for the pentacene systems were performed and a single CI iteration calculation with an active space of 24 electrons in 24 orbitals for the chromium tetramer was possible. The chromium tetramer corresponds to a CI expansion of one trillion Slater determinants (914 058 513 424) and is the largest conventional CI calculation attempted up to date.
15 September 2015 in The Journal of Chemical Physics
A novel algorithm for performing configuration interaction (CI) calculations using non-orthogonal orbitals is introduced. In the new algorithm, the explicit calculation of the Hamiltonian matrix is replaced by the direct evaluation of the Hamiltonian matrix times a vector, which allows expressing the CI-vector in a bi-orthonormal basis, thereby drastically reducing the computational complexity. A new non-orthogonal orbital optimization method that employs exponential mappings is also described. To allow non-orthogonal transformations of the orbitals, the standard exponential mapping using anti-symmetric operators is supplemented with an exponential mapping based on a symmetric operator in the active orbital space. Expressions are obtained for the orbital gradient and Hessian, which involve the calculation of at most two-body density matrices, thereby avoiding the time-consuming calculation of the three- and four-body density matrices of the previous approaches. An approach that completely avoids the calculation of any four-body terms with limited degradation of convergence is also devised. The novel methods for non-orthogonal configuration interaction and orbital optimization are applied to the chromium dimer and trimer. For internuclear distances that are typical for chromium clusters, it is shown that a reference configuration consisting of optimized singly occupied active orbitals is sufficient to give a potential curve that is in qualitative agreement with complete active space self-consistent field (CASSCF) calculations containing more than 500 × 106 determinants. To obtain a potential curve that deviates from the CASSCF curve by less than 1 mHartree, it is sufficient to add single and double excitations out from the reference configuration.
18 March 2015 in The Journal of Chemical Physics
The time-dependent Schrödinger equation for a time-periodic perturbation is recasted into a Hermitian eigenvalue equation, where the quasi-energy is an eigenvalue and the time-periodic regular wave function an eigenstate. From this Hermitian eigenvalue equation, a rigorous and transparent formulation of response function theory is developed where (i) molecular properties are defined as derivatives of the quasi-energy with respect to perturbation strengths, (ii) the quasi-energy can be determined from the time-periodic regular wave function using a variational principle or via projection, and (iii) the parametrization of the unperturbed state can differ from the parametrization of the time evolution of this state. This development brings the definition of molecular properties and their determination on par for static and time-periodic perturbations and removes inaccuracies and inconsistencies of previous response function theory formulations. The development where the parametrization of the unperturbed state and its time evolution may differ also extends the range of the wave function models for which response functions can be determined. The simplicity and universality of the presented formulation is illustrated by applying it to the configuration interaction (CI) and the coupled cluster (CC) wave function models and by introducing a new model—the coupled cluster configuration interaction (CC-CI) model—where a coupled cluster exponential parametrization is used for the unperturbed state and a linear parametrization for its time evolution. For static perturbations, the CC-CI response functions are shown to be the analytical analogues of the static molecular properties obtained from finite field equation-of-motion coupled cluster (EOMCC) energy calculations. The structural similarities and differences between the CI, CC, and CC-CI response functions are also discussed with emphasis on linear versus non-linear parametrizations and the size-extensivity of the obtained molecular properties.
7 November 2006 in The Journal of Chemical Physics
The active space approach for coupled-cluster models is generalized using the general active space concept and implemented in a string-based general coupled-cluster code. Particular attention is devoted to the choice of orbitals on which the subspace division is based. Seminatural orbitals are proposed for that purpose. These orbitals are obtained by diagonalizing only the hole-hole and particle-particle block of the one-electron density of a lower-order method. The seminatural orbitals are shown to be a good replacement for complete active space self-consistent field orbitals and avoid the ambiguities with respect to the reference determinant introduced by the latter orbitals. The seminatural orbitals also perform well in excited state calculations, including excited states with strong double excitation contributions, which usually are difficult to describe with standard coupled-cluster methods. A set of vertical excitation energies is obtained and benchmarked against full configuration interaction calculations, and alternative hierarchies of active space coupled-cluster models are proposed. As a simple application the spectroscopic constants of the C2 BΔg1 and B′Σg+1 states are calculated using active space coupled-cluster methods and basis sets up to quadruple-zeta quality in connection with extrapolation and additivity schemes.
8 January 2016 in The Journal of Chemical Physics
Molecular response properties for ground and excited states and for transitions between these states are defined by solving the time-dependent Schrödinger equation for a molecular system in a field of a time-periodic perturbation. In equation of motion coupled cluster (EOM-CC) theory, molecular response properties are commonly obtained by replacing, in configuration interaction (CI) molecular response property expressions, the energies and eigenstates of the CI eigenvalue equation with the energies and eigenstates of the EOM-CC eigenvalue equation. We show here that EOM-CC molecular response properties are identical to the molecular response properties that are obtained in the coupled cluster–configuration interaction (CC-CI) model, where the time-dependent Schrödinger equation is solved using an exponential (coupled cluster) parametrization to describe the unperturbed system and a linear (configuration interaction) parametrization to describe the time evolution of the unperturbed system. The equivalence between EOM-CC and CC-CI molecular response properties only holds when the CI molecular response property expressions—from which the EOM-CC expressions are derived—are determined using projection and not using the variational principle. In a previous article [F. Pawłowski, J. Olsen, and P. Jørgensen, J. Chem. Phys. 142, 114109 (2015)], it was stated that the equivalence between EOM-CC and CC-CI molecular response properties only held for a linear response function, whereas quadratic and higher order response functions were mistakenly said to differ in the two approaches. Proving the general equivalence between EOM-CC and CC-CI molecular response properties is a challenging task, that is undertaken in this article. Proving this equivalence not only corrects the previous incorrect statement but also first and foremost leads to a new, time-dependent, perspective for understanding the basic assumptions on which the EOM-CC molecular response property expressions are founded. Further, the equivalence between EOM-CC and CC-CI molecular response properties highlights how static molecular response properties can be obtained from finite-field EOM-CC energy calculations.