26 December 2016 in IEEE Transactions on Microwave Theory and Techniques
This paper reports on tunable 2- and 3-pole bandpass filters with a wide frequency tuning range (tuning ratio >3) and a constant bandwidth using switchable varactor-tuned resonators. The wide center frequency tuning range is obtained using p-i-n diodes to switch in and out quarter-wavelength (λ/4) or half-wavelength (λ/2) resonators for low-band or high-band modes, without increasing the tuning capacitance range of the varactors. A combination of electric and magnetic coupling is utilized to realize a near constant absolute bandwidth across the tuning range. A switchable feed line with a fixed matching capacitance is used to realize the external coupling. Two filters are designed and fabricated on a Duroid substrate with ε r = 2.2 and h = 0.787 mm. For the 2-pole filter, the center frequency is tuned from 550 to 1900 MHz while maintaining a 3-dB bandwidth of 92 ± 6 MHz, insertion loss of 3.2~4.4 dB, and return loss of better than 15 dB. For the 3-pole filter, the center frequency is tuned from 540 to 1800 MHz while maintaining a 3-dB bandwidth of 89 ± 4 MHz, insertion loss of 4~5.4 dB, and return loss of better than 12 dB. For both filter types, the third-order intercept point and 1-dB compression point (P 1 dB) are 11 and 7 dBm, respectively. The rejection level at 200-MHz offset frequency from the passband center frequency is better than 25 and 41 dB for 2- and 3-pole filters, respectively, across the entire tuning range. To the best of our knowledge, this planar bandpass filter exhibits the widest tuning range with a near-constant bandwidth.
26 July 2021 in IEEE Transactions on Antennas and Propagation
In this article, a dual-band substrate integrated waveguide (SIW) filtering antenna with improved out-of-band rejection is presented. It consists of two dual-mode rectangular cavity resonators integrated with the slot antenna. Four metal–insulator–metal (MIM) capacitors are designed in the first cavity to realize circuit miniaturization and wide upper stopband. The second slot-loaded cavity achieves a miniaturized dual-band radiation by cutting the currents of TE 110 and TE 210 modes. Three radiation nulls are obtained due to the multiple coupling paths between the resonating and spurious modes. The radiation nulls locations can also be adjusted by changing the feeding position. For verification, a SIW filtering antenna operating at 3.6/4.1 GHz ( $f_{1}/f_{2}$ ) is designed and fabricated. The measured peak gain and 10 dB bandwidth at low band of 3.57 GHz (high band of 4.12 GHz) are 4.84 dBi (4.85 dBi) and 2.3% (1.6%), respectively. The measured >30 dB inner stopband suppression and 20 dB upper stopband suppression up to $1.46f_{2}$ are achieved.
30 October 2019 in IEEE Transactions on Microwave Theory and Techniques
This article reports on the design of continuously tunable true-time-delay (TTD) phase shifter using transmission lines with simultaneously reconfigurable impedance and phase constant. The reconfigurable transmission lines are designed with an independent control of equivalent series inductance and capacitance, which thus can achieve tunable phase constant (i.e., phase shift) while maintaining constant characteristic impedance. With the perfect matching property for all tuning states of phase constant, the proposed reconfigurable transmission-line units are cascaded to construct a tunable TTD phase shifter. For the proof-of-concept demonstration, three TTD phase shifters based on the proposed reconfigurable transmission lines with phase shifts of 45°, 90°, and 180° at center frequency of 1 GHz (f 0 ) are designed and fabricated. The measured 2-unit phase shifter is tuned from -128° to -175° at f 0 while the insertion loss is better than 0.8 dB. The return loss is better than 15 dB from dc to 1.28 f 0 . For the 4-unit phase shifter, the phase shift tuning range is 93° at f 0 with insertion loss better than 1.4 dB. The return loss is better than 15 dB from dc to 1.03 f 0 for all states. The 8-unit phase shifter shows a measured tuning range of 183° at f 0 with insertion loss better than 2.0 dB. The return loss is better than 15 dB from dc to 1.03 f 0 for all states. The measured continuously tunable delay time is 507 ps. The measured 1-dB compression point is better than 12 dBm at f 0 for all states. As compared with the state-of-the-arts, the main merits of the proposed phase shifter are large phase shift/unit and wide matching bandwidth.
15 April 2022 in IEEE Transactions on Microwave Theory and Techniques
This article presents a broadband three-stage pseudoload modulated balanced amplifier (P-LMBA) with enhanced power back-off efficiency. Unlike the conventional LMBAs, one of the balanced PA pairs of the proposed P-LMBA is modified to serve as the carrier amplifier, while the other one and the control amplifier (CA) are working as the peaking amplifiers. A new load combining network is designed to dynamically modulate the load impedance of the three PAs. Thus, the three PAs working in voltage saturation achieve peak efficiency at two different back-off and saturation points. This new load modulation mechanism enables the P-LMBA to greatly extend the back-off range and significantly enhance the power back-off efficiency. Based on the proposed theory, a three-stage P-LMBA operating from 1.6 to 2.0 GHz (22%) is designed and measured. Under the continuous-wave excitation, the measured 10-dB back-off, 6-dB back-off, and saturation efficiencies are 49%–62%, 52.4%–64.8%, and 65%–75%, respectively. The measured 10-dB back-off gain and saturation gain are 8.5–9.7 and 7.2–9.7 dB, respectively. When driven by a 20-MHz long-term evolution (LTE)-modulated signal with a 10.32-dB peak-to-average power ratio (PAPR), the proposed P-LMBA achieves an average efficiency of 42.8%–54.6% and the adjacent channel power ratios of −23.5 to −30.76 dBc.
17 July 2017 in IEEE Transactions on Microwave Theory and Techniques
This paper reports on, for the first time, the design and implementation of planar balanced tunable power dividers. The wide power-dividing tuning range is obtained by using two tuning capacitors and a single control voltage. The differential-mode operation, common-mode rejection, and cross-mode conversion suppression are realized for all tuning states. Closed-form equations for design parameters are derived. For verification, a power divider operating at 1 GHz with power-dividing tuning ratio of 0.01-3.61 is designed based on the given closed-form design equations. Finally, a microstrip tunable power divider with two varactor diodes MA46H202 is fabricated and measured. The measured results are in good agreement with the simulated ones.
19 April 2022 in IEEE Antennas and Wireless Propagation Letters
This letter presents a dual-polarized filtering patch antenna with high gain, low cross-polarization, and without extra filtering circuits. By etching the slots on the patch, a radiation null at the upper band edge is generated, while introducing an extra resonant mode to broaden the impedance bandwidth. In addition, four shorting pins are symmetrically loaded on the patch, which provides a radiation null at the lower band edge and the enhanced gain. Moreover, the cross-polarization level is reduced by adopting the symmetrical structure and a differential feeding scheme. For verification, a filtering antenna operating at 5G n77 band (3.3–4.2 GHz) is designed and fabricated. The measured 10 dB bandwidth is 29.7% (3.15–4.25 GHz) with a peak gain of 9.5 dBi, a cross-polarization level of less than −32 dB and an isolation of higher than 34 dB. The out-of-band suppression levels are more than 34 and 16 dB within the lower stopband (1–2.52 GHz) and the upper stopband (4.6–6.5 GHz), respectively.