One of the promising methods for improving the uniformity of seed distribution in the soil is the control of the grain flow by guiding elements in the openers. This creates favorable conditions for the flight of seeds in the openers and when leaving them backwards, which equalizes the speed, in modulus, of seeds and the unit, improves the uniformity of their distribution in the soil. The presence and parameters of the guiding elements of the openers was theoretically substantiated, which gave the development of the process of controlling the grain flow in the openers and at the exit from them by using the guiding elements. Analytical expressions have been obtained to determine the characteristics of the movement of particles on various surfaces, which are recommended to be used for guides in the openers. Experimental studies have shown that openers with guides reduce the coefficient of variation along the row by 20 ... 45% and have it 88 ... 98%, and in depth - 24 ... 27%. On the basis of experiments, it is recommended that 3 ... 4 guides are recommended for front openers (arithmetic mean interval along the row 18.5 ... 23.5 mm, coefficient of variation 88 ... 98%). The advantage of the experimental opener in the distribution of seeds by depth is due to the use of guide elements in combination with an improved soil shedding process. This eliminated the technological drawback - the formation of a sub-opener inclined surface (arithmetic mean interval 42 ... 37 mm, coefficient of variation 24 ... 27%). For a double disc opener, an improved guide is recommended, the bottom edge of which protrudes 2 cm in front of the vertical diameter of the discs and is located at a distance of 9 cm from the reference plane. The arithmetic mean spacing along the row of this opener is 15 mm, the coefficient of variation is 106%.
26 February 2021 in Eastern-European Journal of Enterprise Technologies
This paper reports a study into the phase composition and microstructure of tungsten ore concentrate after carbon-thermal reduction at different O:C ratios in the charge. This is required for determining those indicators that reduce tungsten loss through the sublimation of oxide compounds when processing ore concentrates, as well as when using reduced tungsten-containing doping additives. The study results have established that the reduced tungsten concentrate at the O:C ratio in the charge within the interval of 1.33‒2.30 contained the phases of W, W2C C, C, WO2. The microstructure demonstrated a spongy and disordered character. Together with W, the Mo, Si, Ca, Al impurities were present in the reduced products. The main elements identified at the sites studied had the following limiting content, % by weight: O – 5.01–17.32; C – 0.84–4.23; W – 61.21–86.78; Mo – 1.57–7.51; Si – 2.07–9.06; Ca – 1.34–11.30; Al – 0.27–0.40. The micro-inclusions at the examined surface areas acquired different complex shapes. There were traces of the process of caking between the particles. The analysis of the resulting data has shown that the most preferred ratio of O:C in the charge was 1.65. In this case, there is no lack of carbon and there is a predominance of W in the phase composition with a relatively little manifestation of the W2C phases, carbon, as well as the residual part of WO2. The post-reduction of the oxide component would occur during the doping process. The sponge structure contributes to a higher dissolution rate compared to standard tungsten ferroalloys. Lack of compounds with a relatively high propensity for sublimation does not require any special conditions to prevent the loss of tungsten in the gas phase, which increases the degree of assimilation of the target element