19 February 2023 in KSCE Journal of Civil Engineering
Grouting technology is an important method that has been widely adopted for the crack repair of tunnel lining, but the diffusion law of grouting slurry is still uncertain in tunnel lining cracks. For the sake of exploring the grouting diffusion law of tunnel lining cracks, this paper investigated the grouting diffusion shape and the relation between the diffusion radius and time with different crack widths in tunnel lining which by means of laboratory experiments and statistical analysis. Meanwhile, the diffusion equation of grouting in lining cracks has been established on basis of the grouting diffusion shape and experimental data. Furthermore, it is analyzed the correlation between the experimental values and the calculated values. The results revealed that the diffusion shape can be divided into a circular zone, excessive zone, and elliptical zone in the tunnel lining cracks, and the calculated values of the equation of grouting diffusion are highly correlated with the experimental values. Additionally, it is shown that the diffusion equation can accurately describe the relationship between diffusion radius and time of grouting in tunnel lining cracks. The study results would provide a theoretical basis for the prediction of diffusion radius on grouting repair for tunnel lining cracks.
29 September 2022 in Advances in Materials Science and Engineering
To promote practical use of the top-and-bottom layered steel fiber reinforced concrete (LSFRC) plates, an appropriate constitutive model is selected using ABAQUS software to analyze the bearing capacity, failure pattern, and deformation of the LSFRC plates. An LSFRC plate model is established for the analysis and calculation. Meanwhile, a test was carried out to measure the bearing capacity of 10 LSFRC plates. The results show that, after going through the elastic stage, crack growth, and failure stage, when the maximum crack width reaches 0.1 mm, the load of the LSFRC plates can be used as the ultimate bearing load. When failure appears to be bending the LSFRC plates, the neutral axis will shift upwards, showing a pseudoplastic failure. There is a larger tensile stress area after the first crack appears at the bottom of the steel fiber concrete. The change before and after the maximum load is relatively gentle. After becoming plastic, the plate witnesses a rapid crack growth on its bottom. With similar results from the test and numerical simulation, small errors can be minimized by further analysis to provide a more accurate model for the subsequent bearing capacity analysis of the LSFRC plates.