Characterizing and attributing methane (CH4) emissions across varying scales are important from environmental, safety, and economic perspectives and are essential for designing and evaluating effective mitigation strategies. Mobile real-time measurements of CH4 in ambient air offer a fast and effective method to identify and quantify local CH4 emissions in urban areas. We carried out extensive campaigns to measure CH4 mole fractions at the street level in Utrecht, the Netherlands (2018 and 2019), and Hamburg, Germany (2018). We detected 145 leak indications (LIs; i.e., CH4 enhancements of more than 10 % above background levels) in Hamburg and 81 LIs in Utrecht. Measurements of the ethane-to-methane ratio (C2:C1), methane-to-carbon dioxide ratio (CH4:CO2), and CH4 isotope composition (δ13C and δD) show that in Hamburg about 1∕3 of the LIs, and in Utrecht 2∕3 of the LIs (based on a limited set of C2:C1 measurements), were of fossil fuel origin. We find that in both cities the largest emission rates in the identified LI distribution are from fossil fuel sources. In Hamburg, the lower emission rates in the identified LI distribution are often associated with biogenic characteristics or (partly) combustion. Extrapolation of detected LI rates along the roads driven to the gas distribution pipes in the entire road network yields total emissions from sources that can be quantified in the street-level surveys of 440±70 t yr−1 from all sources in Hamburg and 150±50 t yr−1 for Utrecht. In Hamburg, C2:C1, CH4:CO2, and isotope-based source attributions show that 50 %–80 % of all emissions originate from the natural gas distribution network; in Utrecht more limited attribution indicates that 70 %–90 % of the emissions are of fossil origin. Our results confirm previous observations that a few large LIs, creating a heavy tail, are responsible for a significant proportion of fossil CH4 emissions. In Utrecht, 1∕3 of total emissions originated from one LI and in Hamburg from two LIs. The largest leaks were located and fixed quickly by GasNetz Hamburg once the LIs were shared, but 80 % of the (smaller) LIs attributed to the fossil category could not be detected and/or confirmed as pipeline leaks. This issue requires further investigation.
Methane (CH4) emissions from human activities are a threat to the resilience of our current climate system. The stable isotopic composition of methane (δ13C and δ2H) allows us to distinguish between the different CH4 origins. A significant part of the European CH4 emissions, 3.6 % in 2018, comes from coal extraction in Poland, the Upper Silesian Coal Basin (USCB) being the main hotspot. Measurements of CH4 mole fraction (χ(CH4)), δ13C, and δ2H in CH4 in ambient air were performed continuously during 6 months in 2018 and 2019 at Krakow, Poland, in the east of the USCB. In addition, air samples were collected during parallel mobile campaigns, from multiple CH4 sources in the footprint area of the continuous measurements. The resulting isotopic signatures from sampled plumes allowed us to distinguish between natural gas leaks, coal mine fugitive emissions, landfill and sewage, and ruminants. The use of δ2H in CH4 is crucial to distinguish the fossil fuel emissions in the case of Krakow because their relatively depleted δ13C values overlap with the ones of microbial sources. The observed χ(CH4) time series showed regular daily night-time accumulations, sometimes combined with irregular pollution events during the day. The isotopic signatures of each peak were obtained using the Keeling plot method and generally fall in the range of thermogenic CH4 formation – with δ13C between −59.3 ‰ and −37.4 ‰ Vienna Pee Dee Belemnite (V-PDB) and δ2H between −291 ‰ and −137 ‰ Vienna Standard Mean Ocean Water (V-SMOW). They compare well with the signatures measured for gas leaks in Krakow and USCB mines. The CHIMERE transport model was used to compute the CH4 and isotopic composition time series in Krakow, based on two emission inventories. The magnitude of the pollution events is generally underestimated in the model, which suggests that emission rates in the inventories are too low. The simulated isotopic source signatures, obtained with Keeling plots on each simulated peak, indicate that a higher contribution from fuel combustion sources in the EDGAR v5.0 inventory would lead to a better agreement than when using CAMS-REG-GHG v4.2 (Copernicus Atmosphere Monitoring Service REGional inventory for Air Pollutants and GreenHouse Gases). The isotopic mismatches between model and observations are mainly caused by uncertainties in the assigned isotopic signatures for each source category and the way they are classified in the inventory. These uncertainties are larger for emissions close to the study site, which are more heterogenous than the ones advected from the USCB coal mines. Our isotope approach proves to be very sensitive in this region, thus helping to evaluate emission estimates.
Recent climate change mitigation strategies rely on the reduction of methane (CH4) emissions. Carbon and hydrogen isotope ratio (δ13C and δ2H ) measurements can be used to distinguish sources and thus to understand the CH4 budget better. The CH4 emission estimates by models are sensitive to the isotopic signatures assigned to each source category, so it is important to provide representative estimates of the different CH4 source isotopic signatures worldwide. We present new measurements of isotope signatures of various, mainly anthropogenic, CH4 sources in Europe, which represent a substantial contribution to the global dataset of source isotopic measurements from the literature, especially for δ2H . They improve the definition of δ13C from waste sources, and demonstrate the use of δ2H for fossil fuel source attribution. We combined our new measurements with the last published database of CH4 isotopic signatures and with additional literature, and present a new global database. We found that microbial sources are generally well characterised. The large variability in fossil fuel isotopic compositions requires particular care in the choice of weighting criteria for the calculation of a representative global value. The global dataset could be further improved by measurements from African, South American, and Asian countries, and more measurements from pyrogenic sources. We improved the source characterisation of CH4 emissions using stable isotopes and associated uncertainty, to be used in top-down studies. We emphasise that an appropriate use of the database requires the analysis of specific parameters in relation to source type and the region of interest. The final version of the European CH4 isotope database coupled with a global inventory of fossil and non-fossil δ13C and δ2H source signature measurements is available at https://doi.org/10.24416/UU01-YP43IN (Menoud et al., 2022 a).
In regions where there are multiple sources of methane (CH4) in close proximity, it can be difficult to apportion the CH4 measured in the atmosphere to the appropriate sources. In the Surat Basin, Queensland, Australia, coal seam gas (CSG) developments are surrounded by cattle feedlots, grazing cattle, piggeries, coal mines, urban centres and natural sources of CH4. The characterization of carbon (δ13C) and hydrogen (δD) stable isotopic composition of CH4 can help distinguish between specific emitters of CH4. However, in Australia there is a paucity of data on the various isotopic signatures of the different source types. This research examines whether dual isotopic signatures of CH4 can be used to distinguish between sources of CH4 in the Surat Basin. We also highlight the benefits of sampling at nighttime. During two campaigns in 2018 and 2019, a mobile CH4 monitoring system was used to detect CH4 plumes. Sixteen plumes immediately downwind from known CH4 sources (or individual facilities) were sampled and analysed for their CH4 mole fraction and and signatures. The isotopic signatures of the CH4 sources were determined using the Keeling plot method. These new source signatures were then compared to values documented in reports and peer-reviewed journal articles. In the Surat Basin, CSG sources have signatures between −55.6 ‰ and −50.9 ‰ and signatures between −207.1 ‰ and −193.8 ‰. Emissions from an open-cut coal mine have and signatures of ‰ and ‰ respectively. Emissions from two ground seeps (abandoned coal exploration wells) have signatures of ‰ and ‰ and signatures of ‰ and ‰. A river seep had a signature of ‰ and a signature of ‰. Three dominant agricultural sources were analysed. The and signatures of a cattle feedlot are ‰ and ‰ respectively, grazing (pasture) cattle have and signatures of ‰ and ‰ respectively, and a piggery sampled had and signatures of ‰ and ‰ respectively, which reflects emissions from animal waste. An export abattoir (meat works and processing) had and signatures of ‰ and ‰ respectively. A plume from a wastewater treatment plant had and signatures of ‰ and ‰ respectively. In the Surat Basin, source attribution is possible when both and are measured for the key categories of CSG, cattle, waste from feedlots and piggeries, and water treatment plants. Under most field situations using alone will not enable clear source attribution. It is common in the Surat Basin for CSG and feedlot facilities to be co-located. Measurement of both and will assist in source apportionment where the plumes from two such sources are mixed.
1 January 2020 in Tellus B: Chemical and Physical Meteorology
Despite the importance of methane for climate change mitigation, uncertainties regarding the temporal and spatial variability of the emissions remain. Measurements of CH4 isotopic composition are used to partition the relative contributions of different emission sources. We report continuous isotopic measurements during 5 months at the Lutjewad tower (north of the Netherlands). Time-series of χ(CH4), δ13C-CH4, and δD-CH4 in ambient air were analysed using the Keeling plot method. Resulting source signatures ranged from −67.4 to −52.4‰ vs V-PDB and from −372 to −211‰ vs V-SMOW, for δ13C and δD respectively, indicating a prevalence of biogenic sources. Analysis of isotope and wind data indicated that (i) emissions from off-shore oil and gas platforms in the North Sea were not detected during this period, (ii) CH4 from fossil fuel related sources was usually advected from the east, pointing towards the Groningen gas field or regions further east in Germany. The results from two atmospheric transport models, CHIMERE and FLEXPART-COSMO, using the EDGAR v4.3.2 and TNO-MACC III emission inventories, reproduce χ(CH4) variations relatively well, but the isotope signatures were over-estimated by the model compared to the observations. Accounting for geographical variations of the δ13C signatures from fossil fuel emissions improved the model results significantly. The difference between model and measured isotopic signatures was larger when using TNO-MACC III compared to EDGAR v4.3.2 inventory. Uncertainties in the isotope signatures of the sources could explain a significant fraction of the discrepancy, thus a better source characterisation could further strengthen the use of isotopes in constraining emissions.