Bu çalışma kapsamında profil çekme makinesinden çıkan atık dahoma odun ununun polipropilen (PP) bazlı odun plastik kompozit üretiminde dolgu maddesi olarak kullanımının kompozit malzemelerin mekanik ve morfolojik özellikleri üzerine etkileri incelenmiştir. Atık odun unları fabrikadan alındığı gibi ve dört farklı oranda (%0, %15, %30 ve %45) kullanılmıştır. Atık odun unlarının boyut analizi gerçekleştirilmiştir. Uyumlaştırıcı olarak %3 oranında maleik anhidrit polipropilen (MAPP) ve yağlayıcı olarak %3 parafin wax kullanılmıştır. Elde edilen sonuçlar neticesinde odun ununun eklenmesi ile çekme ve darbe direnci değerlerinde hafif dalgalanmalar gözlemlense de genel olarak mekanik değerlerde iyileşmeler belirlenmiştir. Odun ununun katılım oranının artması ile çekmede elastikiyet modülü, eğilme direnci ve eğilmede elastikiyet modülü özellikleri iyileşmiştir. Kopmada uzama değerlerinde ise keskin bir düşüş gözlemlenmiştir. Morfolojik özellikleri incelendiğinde odun ununun homojen bir şekilde polimer matris içerisinde dağılım gösterdiği ve polimer matrisin dolgu maddelerinin etrafını iyice sardığı ve iyi bir arayüz etkileşiminin olduğu gözlemlenmiştir. Sonuç olarak, atık dahoma odun unlarının odun plastik kompozit üretiminde değerlendirilebileceği kanaatine varılmıştır.
31 October 2021 in TURKISH JOURNAL OF FOREST SCIENCE
The objective of this study was to investigate the utilization of waste tea wood fibers (WTWF) and effect of maleic anhydride treated polyethylene (MAPE) in thermoplastic composites. For this purpose, HDPE as matrix, WTWF as lignocellulosic filler and MAPE as coupling agent were used. Six different composites were produced by injection molding method; 0-15-30% WTWF filler ratio, with MAPE and without MAPE. The physical, mechanical, thermal and morphological properties of composite materials were determined. As a result, tensile strength, tensile modulus, flexural strength and flexural modulus of the composites were increased with the rise of the WTWF amount in the thermoplastic matrix. However, WTWF increase in the thermoplastic matrix reduced the elongation at break and impact strength of the produced composites. Addition of MAPE in thermoplastic matrix improved tensile strength, flexural strength and flexural modulus of manufactured composites. In the case of thermal properties, addition of WTWF into the thermoplastic matrix increased the char rate of the composites. However, the initial degradation did not change. It appears that waste tea wood fibers may have a potential usage as filler in the HDPE-based thermoplastic composites.