School of Chemistry Key Laboratory of Advanced Technologies of Materials (Ministry of Education) Southwest Jiaotong University Chengdu People's Republic of China
Auto-generated profile, based on publicly available information
Peng Huang
School of Chemistry Key Laboratory of Advanced Technologies of Materials (Ministry of Education) Southwest Jiaotong University Chengdu People's Republic of China
Semi-transparent perovskite solar cells (Pero-SCs) are realized by tuning the band gap of the perovskite to resolve the trade-off between the transparency and efficiency of the photo-absorber. We synthesized wide-bandgap MAPbI3−xBrx perovskite, and the transparency and efficiency of the corresponding semi-transparent Pero-SCs were investigated systematically by varying the I : Br ratio and thickness of the perovskite film. Increasing Br content widened the bandgap of perovskite (i.e., blue shift of the absorption edge), and led to an increase in the average visible transmittance (AVT). This strategy allowed for high AVTs, and concomitantly achieved high power conversion efficiencies. Meanwhile, increasing the Br content could facilitate formation of perovskite films with large grains that were highly crystallized. Compared with the narrow-bandgap perovskite, the wide-bandgap perovskite showed advantages for obtaining semi-transparent Pero-SCs with thick perovskite films (>200 nm) and high (20%) transparency.
16 February 2019 in Journal of Materials Chemistry A
In planar n–i–p perovskite solar cells (Pero-SCs), interfacial engineering plays a critically important role in charge extraction and transportation, and hence influences the photovoltaic performances. In this study, high performance Pero-SCs were realized by introducing SnO2/2D TiS2 double structures as electron transport layers (ETLs). The highest power conversion efficiency (PCE) reached 21.73% (average PCE is 20.48 ± 0.50%) with quite small hysteresis. The improvement of performance is mainly attributed to the facilitated charge transportation due to the match of energy levels and decreased electron trap state densities of ETL films. This work provides not only a promising interfacial material, but also a feasible clue to alleviate the trap states of SnO2 in planar n–i–p Pero-SCs.
For perovskite solar cells (Pero-SCs), one of the key issues with respect to the power conversion efficiency (PCE) is the morphology control of the perovskite thin-films. In this study, an easily-accessible additive polyethylenimine (PEI) is utilized to tune the morphology of CH3NH3PbI3−xClx. With addition of 1.00 wt% of PEI, the smoothness and crystallinity of the perovskite were greatly improved, which were characterized by scanning electron microscopy (SEM) and X-ray diffraction (XRD). A summit PCE of 14.07% was achieved for the p-i-n type Pero-SC, indicating a 26% increase compared to those of the devices without the additive. Both photoluminescence (PL) and alternating current impedance spectroscopy (ACIS) analyses confirm the efficiency results after the addition of PEI. This study provides a low-cost polymer additive candidate for tuning the morphology of perovskite thin-films, and might be a new clue for the mass production of Pero-SCs.
10 April 2018 in ACS Applied Materials & Interfaces