Rajab Ghabour

Rajab Ghabour

Auto-generated profile, based on publicly available information

Rajab Ghabour

Hungarian University of Agriculture and Life Sciences, Mechanical Engineering Doctoral School

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 December 2021 in Science, Technology and Innovation
Verified
Journal Article
Open access
RGRajab Ghabour
Rajab Ghabour
PKPéter Emőd Korzenszky
Péter Emőd Korzenszky
The boiler is an enclosed vessel that transfers the energy from fuel combustion or electricity into hot water or steam. Then, this hot water or pressurized steam is used for transferring the heat to a certain heat process. Usually, the required hot water or steam keeps on varying throughout the day which also may be implied on the daily or monthly load. Therefore, several configurations of connecting the boiler into the solar heating system ensure the temperature of the final output. The boiler can be connected in series or parallel to improve the efficiency of the overall process as well as to reduce the running costs. This paper presents a simulation study of a solar heating system for industrial processes. Two flow-heater system configurations are designed for covering the heat demand of a pasteurising factory existing in Budapest, Hungary. The configuration “A” consists of a solar heating system for hot water preparation using in series flow heater configuration. While configuration “B” consists of the same solar system but with a parallel flow heater configuration. These system configurations are modelled using T*sol software for evaluating the system performance under the Hungarian climate from five different aspects: required collector area, glycol ratio, volume flow rate, relative tank capacity, and tank height-to-diameter ratio. According to the optimum design parameters, in series configuration is better than parallel by 3.14% at 45 m² collector area, 0.45% at 25% glycol ratio, 0.42% at 50 l/h · m² volume flow rate, 2.05% at 50 l/m² relative tank capacity, and 0.42% at 1.8 tank height-to-diameter ratio respectively. The results show that in series configuration is better in terms of solar fractions than parallel configuration from all five aspects.

16 January 2023 in Analecta Technica Szegedinensia
Verified
Journal Article
Open access
PDF file
RGRajab Ghabour
Rajab Ghabour
PKPéter Emőd Korzenszky
Péter Emőd Korzenszky
The Visegrád group's energy security is attributed to the national energy potential of each country. The energy potential results from the lack of crude oil and natural gas resources, limited access to the transmission network, and limited fuel storage. This bloc relies on raw material supplies from Russia, which is not evenly applied to all group members. Poland and Hungary have good storing potential, but it is not enough to achieve energy security and independence. Russia aims to keep control of this market while group members try diversifying their supplies to increase energy security. The purpose of this article is to present the energy balance in the Visegrád region. The analysis is based on the status of the renewable energy targets in the production, demand, import and export. Also, to determine the stability degree of these energy parameters. The material source is the literature and the energetic data from the European statistic's official agency Eurostat and European commission reports. From an energetic aspect, the four capitals were considered as a case study for a food processing plant with annual hot water demand of 43 MWh to evaluate the performance of the solar thermal energy. The simulation was conducted using T*Sol software considering 16 evacuated-tube collectors B. Schweizer Energy AG manufacturer. The chosen process heating system has a buffer tank and a continuous flow heater. Each collector was inclined according to the optimum angle for each case study. As a result, it was found that the energy demand in the Visegrád region is entirely related to the economic situation. In contrast, Political and energy development have a more significant impact than economic factors. From an energetic aspect, solar thermal energy is evident for Hungary and Slovakia since they have up to 20% solar yields compared to Poland and the Czech Republic. Nevertheless, the solar irradiation on the collector field is high enough to consider solar thermal energy solutions integrated into food and industrial processes.

1 January 2021 in Hungarian Agricultural Engineering
Verified
Journal Article
Open access
RGRajab Ghabour
Rajab Ghabour
PKPéter Emőd Korzenszky
Péter Emőd Korzenszky
With approximately 1.2% growth annually, the industrial sector accounts for 54% of the total consumed energy globally. Most of those facilities use fossil fuels to generate their needs. Renewable energies, mainly solar energy, can play a major role in meeting the global policies of reducing carbon dioxide emissions. Presently, Hungarian researchers exploit more energy from renewable energies such as solar sources, wind, and biomass. Knowing that reducing the carbon emission level is a general tendency in Hungary. This article presents an extensive analysis of the solar thermal system in the central European climate, especially in Hungary. The scope of this study is the low-to-medium heat generation in industries such as pharmaceutical, pulp & paper textile, food processing and beverages. Through all the applications, the heat is consumed in hot water form. Integrating solar thermal technology in the industrial sector depends mainly on solar radiation, conventional fuel prices, available installation area, and the complexity level of integrating the solar system with the existing process. Furthermore, more challenges show up during the integration of economic difficulties. This article analyses the feasibility of providing industrial hot water for small-to-medium enterprises (SMEs) in different Hungarian counties. The analysis was performed using T*Sol 5.5 software, and metrological data were obtained by MeteoSyn built-in software. Results indicate that the most suitable region for integrating solar thermal energy was Szeged, Szolnok, and Kecskemet, which supplied 54.89%, 54.16%, and 54.03% of the total heat load for the studied case, respectively. This result accounts for 849.57, 840.25 and 839.27 kWh/m2 of specific generated heat of the solar system. In addition, it results in points that the annual carbon dioxide saved amount is up to 4,442.3 kg and 2,100.7 m3 annual amount of natural gas. In conclusion, Hungary has a potentially attractive market for solar thermal systems to provide industrial hot water for small and medium-sized factories.

8 December 2020 in Analecta Technica Szegedinensia
Verified
Journal Article
Closed access
PDF file
RGRajab Ghabour
Rajab Ghabour
PKPéter Emőd Korzenszky
Péter Emőd Korzenszky
Worldwide, governments tend to reduce the CO2 emissions, and the storage of the solar energy system is still considered the most challenging problem to solve under the current state. Mainly, in relatively cold countries, as domestic hot water or for heat process services, where the loss in the tank is huge. Any improvement in the design can achieve a higher solar yield. Since water is the usual medium for heat storage, the integration with phase change material (PCM) can store energy when there is abundant energy and release it when it is needed. In this study, we conducted a capsulated PCM soy wax 52⁰C in an insulated water tank filled with 5 litres of water. To estimate the appropriate number of samples and the quantity of the PCM at two temperature levels using the response surface method with non-linear correlation for the charging phase. The results show 3.16, 0.95, 0.38 first degree magnitude effect for temperature, sample numbers, and wax quantity respectively and 0.29, -0.38 second-degree magnitude effect for quantity and temperature. In addition, an illustration of each two-factors interaction contour plots.

11 December 2023 in Journal of Central European Green Innovation
Verified
Journal Article
Open access
PDF file
GRGhabour Rajab
Ghabour Rajab
HLHaikal Louay
Haikal Louay
A megújuló energiaforrások számtalan fajtája, például a szél, a biomassza és a napenergia könnyen hasznosítható. A legelterjedtebb energia a napenergia; általában különböző célok elérésére használják, mint például a fotovoltaikus/termikus erőművekben történő villamosenergia-termelés és a helyi vízmelegítés. Feladatunk a környezettudatos technológiák bevezetése, ezért a kormányok világszerte ösztönzik az elsődleges felhasználású napenergiával történő vízmelegítést, az alacsony fenntartási költségek és a napenergiával működő fűtési rendszerek hatékonysága miatt. A háztartási napkollektoros melegvíz-egységek –amennyiben hatékonyan vannak megtervezve –költséghatékony módon képesek a legtöbb melegvíz-igényt kielégíteni. Az 50 éves fejlesztés ellenére az üzleti technológia még biztosan nem ért el érdemi piaci előnyt a villamos energia és a gáz alternatívái helyett. A különböző érdekelt felek az épületekben alkalmazott napenergia-fűtési rendszereket a hagyományos helyiség-és vízmelegítési módszerek vonzó alternatívájaként kezelik. Működésük azonban függ az éghajlati viszonyoktól, a tipikus vízmelegítési igényektől, sőt, még a teljesítmény optimalizálására lehetőséget adó működési paraméterektől is.A tanulmány célja, hogy elemezze a csővezetékek paramétereinek hatását a napelemes rendszerre Budapesten, Magyarországon, két program, a T*SOL mint napelemes rendszer szimulátor és az R-Studio mint kódoló szoftver segítségével. Az elemzés a napkollektoros vízmelegítő rendszer egyszerű modelljét használja, figyelembe véve a következő tényezőket (csőátmérő, belső hossz, külső hossz, glikol arány, térfogatáram, szigetelés), azzal a céllal, hogy a belső és külső csőrendszer hatását vizsgálja. A tanulmányt a fent említett változók értékeinek egyidejű változtatásával végzünk lineáris modellezést a kollektor típusának megváltoztatásával, hogy a napenergia-arány szempontjából a legmegfelelőbb rendszert válasszuk ki.