On-machine measurement (OMM) accuracy for freeform surface workpieces is greatly reduced by the error of the touch-trigger probe. Existing methods typically perform probe error compensation under the assumption of vertical measurement. However, due to possible workpiece deformation or unknown workpiece models, the approaching direction inevitably deviates from the normal vector of the inspection point, leading to non-vertical OMM. In this paper, the principal differences between vertical and non-vertical OMM processes are clarified first. Compared with vertical OMM, non-vertical OMM results in more complex probe pre-travel errors and introduces the problem of ruby ball radius compensation. Then, a novel touch-trigger probe error compensation strategy for non-vertical OMM is proposed. The pre-travel error of non-vertical OMM is divided into the delay error and the stylus deformation error. The former can be calculated by the approaching speed and OMM systems delay time. The latter could be figured out based on the 3D deformation error map and interpolation methods. The normal vector approximation of the inspection point is iteratively calculated by the B-spline surface fitting to compensate for the stylus deformation error and ruby ball radius simultaneously. For a designed freeform surface workpiece, the proposed strategy improves the non-vertical OMM accuracy by 49% compared with the comparative method.
7 August 2023 in IEEE Transactions on Instrumentation and Measurement
On-machine measurement (OMM) with a touch-trigger probe has been proved to be a promising technology for machining error identification and compensation without involving re-fixturing positioning errors. Sampling strategy is therefore crucial for accurate and efficient surface inspection. Existing sampling strategies generally distribute sample points only based on the information of the design surface. The sample points might be insufficient in defect areas, causing the reconstructed surface could not represent the actual surface well. In this paper, an intelligent sampling strategy for freeform surfaces is proposed. First, real-time interactive communication between the personal computer and the machine tool computer numerical control (CNC) system is realized by constructing a TCP/IP-based shared folder. Through the shared folder, the sample point planning and OMM inspection are alternately conducted until the predetermined limitation is satisfied. Then, based on two proposed novel sampling criteria, the actual surface information (all the points that have been inspected) is also taken into consideration during the sample point planning. The proposed strategy can optimize the distribution of sample points and automatically set more sample points in the defect. The feasibility and advantages of the proposed strategy are verified by the simulation and experiment. For the tested free-form surface, the maximum reconstruction error is reduced by 68.8% and 79.8% respectively compared with the uniform and adaptive strategies, when the number of sample points is all set as 196.
Impeller blades’ machining accuracy is crucial for the equipment performance. However, the thin and deformable nature of the blades often leads to out-of-tolerance issues during machining. To address this challenge, a novel adaptive machining strategy-based nonvertical on-machine measurement (OMM) is proposed in this article. First, nonvertical OMM is introduced to efficiently identify the blade rough machining allowances online. The noninterference inspection path and the minimum required probe posture are figured out by ray-patch intersection algorithm and greedy algorithm. Additionally, the touch-trigger probe errors, including system delay error, probe deformation error, and ruby ball radius, are precisely identified and compensated to ensure the identification accuracy of machining allowances. Then, the blade sections are adjusted under the constraints of machining allowance and design tolerances by particle swarm algorithm to prevent out-of-tolerance in finish machining. Impeller machining experiments demonstrate the effectiveness of the proposed strategy. Compared to vertical OMM, nonvertical OMM requires only one probe posture for each blade surface and reduces the inspection path length by 44.2%. The five-axis OMM’s average error after probe errors compensation is only 0.0072 mm. By optimizing the blade sections, the final machined blade can meet all tolerances, while the unoptimized blade exhibits out-of-tolerance zone.