Unmanned Aerial Vehicles were first introduced almost 40 years ago and their applications have increased and diversified substantially since then, in both commercial and private use. One of the UAVs main issues when it comes to mobility is that the power sources available are inadequate, this highlights an area for improvement as the interest in drones is on the increase. There exist many different types of power supplies applied to UAVs, however each has their own limitations and strengths that pertain to weight contributions, charging and discharging times, size, payload capabilities, energy density and power density. The aim of this paper is to review the main power sources available for UAVs, determine their shortfalls, compare the power sources with each other and offer suggestions as to how they can be improved – hence identifying where the gap lies for developing better alternative power sources.
1 December 2014 in International Journal of Hydrogen Energy
One of the greatest challenges associated with efficient energy use in unmanned aerial vehicles (drones) is that of the energy storage systems – more specifically it's weight and capacity. Current hydrogen fuel cell drones have very promising flight durations, but have a low power density thus performing poorly at peak power demands. Supercapacitors are known to have high power densities and respond significantly well to peak power demands. For this research it is desired to evaluate how supercapacitors can affect the operation of an existing hydrogen fuel cell system, when combined. This study will include the evaluation of the viability of a DC-DC converter used to reduce the size (and subsequently, weight) of a supercapacitor bank. It also evaluates whether specified switching of the sources has an effect. Using data generated from the experiment it was determined that the DC-DC converter (with efficiency >94%) reduced the efficiency (by 0.5%) and duration (by 3.8%) of the supercapacitor bank whilst increasing the weight (by 16.7%). It was also seen that the method of selective switching offered no benefit over that of a self-selecting system, where the former obtained 223 s of usability and the latter 365 s. However, comparing all the results it was observed that the addition of a supercapacitor bank allowed for an improvement in energy- and power density, of the hydrogen fuel cell system, from 0.65 Wh/kg to 1.19 Wh/kg and from 69.7 W/kg to 125.7 W/kg, respectively.
A Proton Exchange Membrane (PEM) electrolyser is characterised and modelled to identify important electrochemical effects. These electrochemical effects include the ohmic, activation, and concentration losses within the PEM electrolyser during hydrogen production. The electrochemical effects of the PEM electrolyser are modelled by means of equivalent electrical circuits. The equivalent electrical circuit components of importance are the membrane resistance, the charge transfer resistance, the double layer capacitance and the Warburg impedance. The current interrupt method is proposed by using, (i) the natural voltage response method and (ii) system identification, for solving the parameters of the equivalent electrical circuits. In this paper both simulation and experimental results are provided.