16 June 2025 in Cryogenics
16 April 2026 in IEEE Transactions on Applied Superconductivity
Pulsating heat pipes (PHPs) are passive devices using thermally induced two-phase flow. They are increasingly studied in cryogenic conditions to improve heat transfer between cryocoolers and high temperature superconducting (HTS) coils. This paper presents the application of two neon PHPs in simulta neous operation transferring the heat load from an insulated HTS coil under alternating current (AC) operation to a cryocooler. The main objective is to demonstrate the feasibility and quantify the potential benefits of using PHPs for this application. The PHPs, the coil, the experimental setup, procedures and campaigns are described. The experimental results of the coil cooldown and of the AC operation, with cycles of current ramping at 500A/s between 0 and 500A, are analyzed and discussed. The maximum magnetic field at the center of the coil is measured at 0.43T and AC losses dissipate an average heat load of nearly 6.5W. The PHP parameters tested include condenser temperatures of 27 and 30K, as well as filling ratios ranging from 37 to 56%. The two neon PHPs effectively transfer the heat while guaranteeing a low thermal resistance (0.18 to 0.24K/W) and without dry-out phenomenon across four experiments. On average, the temperature difference over the thermal buses is reduced by almost 80% compared to an equivalent copper rod, demonstrating the potential of PHPs for this application.
25 February 2026 in Physical Review Accelerators and Beams
Electron storage rings based on multibend-achromat (MBA) lattices can achieve exceptionally low natural emittances. At the Paul Scherrer Institute in Switzerland, the Swiss Light Source facility underwent an upgrade project, replacing its triple-bend achromat ring with a seven-bend achromat ring. Due to the compact nature of MBA lattices, magnetic fields can be influenced by neighboring magnets. These magnetic crosstalk effects turned out to be significant during the design phase: the integral fields of the magnets could be altered by several percent. We present how we incorporated compensations for these effects into the design and how we tuned the magnets prior to installation. The crosstalk compensations were validated through the accelerator commissioning.