1 September 1990 in Géotechnique
The Paper presents a constitutive model for describing the stress-strain behaviour of partially saturated soils. The model is formulated within the framework of hardening plasticity using two independent sets of stress variables: the excess of total stress over air pressure and the suction. The model is able to represent, in a consistent and unified manner, many of the fundamental features of the behaviour of partially saturated soils which had been treated separately by previously proposed models. On reaching saturation, the model becomes a conventional critical state model. Because experimental evidence is still limited, the model has been kept as simple as possible in order to provide a basic framework from which extensions are possible. The model is intended for partially saturated soils which are slightly or moderately expansive. After formulating the model for isotropic and triaxial stress states, typical predictions are described and compared, in a qualitative way, with characteristic trends of the behaviour of partially saturated soils. Afterwards, the results of a number of suction-controlled laboratory tests on compacted kaolin and a sandy clay are used to evaluate the ability of the model to reproduce, quantitatively, observed behaviour. The agreement between observed and computed results is considered satisfactory and confirms the possibilities of reproducing the most important features of partially saturated soil behaviour using a simple general framework. L'article présente un modèle constitutif pour décrire le comportement contrainte/déformation des sols partiellement saturés. Le modèle est formulé dans le cadre de la plasticité qui s'endurcit, en uti-lisant deux jeux indépendants de variables de contrainte, c'est-à-dire l'excès de la contrainte totale sur la pression de Pair et la succion. Le modèle peut représenter d'une façon logique et unifiée beaucoup des caractéristiques fondamentales du comportement des sols partiellement saturés qui avaient été traités séparément dans des modèles proposés précédemment. Lorsque la saturation est atteinte le modèle devient un modèle conventionnel d'état critique. Comme les données expérimentales restent encore limitées, le modèle d'été simpliné le plus que possible, afin de fournir un cadre de base à partir duquel des extensions sont possibles. Le modèle convicnt à des sols partiellement saturés qui sont expansifs à un degré faible ou modéré. Le modèle est d'abord formulé pour des états de contrainte isotropes et triaxiaux. Puis l'article décrit des prédictions typiques et les compare de façon qualitative avec des tendances caractéristiques du comportement des sols partiellement saturés. Les résultats de quelques essais régis par la succion eftectués dans le laboratoire sur du kaolin compact et sur une argile sablonneuse sont utilisés afin d'evaluer la capacité du modèle de reproduire de façon quantitative le comportement observé. On considère que les résultats observés et calculés s'accordent bien et qu'ils confirment les possibilités de reproduire les caractéristiques les plus importantes du comportement des sols partiellement saturés par l'utilisation d'un cadre général très simple.
1 December 1992 in Canadian Geotechnical Journal
The paper presents a framework for describing the mechanical behaviour of unsaturated expansive clays. It is an extension of an existing formulation developed for unsaturated soils of low activity. The extended framework is based on the distinction within the material of a microstructural level where the basic swelling of the active minerals takes place and a macrostructural level responsible for major structural rearrangements. By adopting simple assumptions concerning the coupling between the two levels, it is possible to reproduce major features of the behaviour of unsaturated expansive clays. Some selected qualitative comparisons between model predictions and experimental results reported in the literature are presented. Despite the simplified hypotheses made, a very encouraging agreement is obtained. Key words : capillarity, clay, model, unsaturation, suction, expansive soils.
1 November 1996 in Engineering Computations
Presents numerical aspects of the program CODE_BRIGHT, which is a simulator for COupled DEformation, BRIne, Gas and Heat transport problems. It solves the equations of mass and energy balance and stress equilibrium and, originally, it was developed for saline media. The governing equations also include a set of constitutive laws and equilibrium conditions. The main peculiarities of saline media are in the dissolution/precipitation phenomena, presence of brine inclusions in the solid salt and creep deformation of the solid matrix.
1 September 1999 in Engineering Geology
1 September 1999 in Engineering Geology
1 January 2010 in Géotechnique
The range of problems that geotechnical engineers must face is increasing in complexity and scope. Often, complexity arises from the interaction between the soil and the environment – the topic of this lecture. To deal with this type of problem, the classical soil mechanics formulation is progressively generalised in order to incorporate the effects of new phenomena and new variables on soil behaviour. Recent advances in unsaturated soil mechanics are presented first: it is shown that they provide a consistent framework for understanding the engineering behaviour of unsaturated soils, and the effects of suction and moisture changes. Building on those developments, soil behaviour is further explored by considering thermal effects for two opposite cases: high temperatures, associated with the problem of storage and disposal of high-level radioactive waste; and low temperatures in problems of freezing ground. Finally, the lecture examines some issues related to chemical effects on soils and rocks, focusing in part on the subject of tunnelling in sulphate-bearing rocks. In each case new environmental variables are identified, enhanced theoretical formulations are established, and new or extended constitutive laws are presented. Particular emphasis is placed on mechanical constitutive equations, as they are especially important in geotechnical engineering. The lecture includes summary accounts of a number of case histories that illustrate the relevance and implications of the developments described for geotechnical engineering practice.