Andrzej Olszewski

Andrzej Olszewski

Auto-generated profile, based on publicly available information

Andrzej Olszewski

University of Warmia and Mazury in Olsztyn, ul. Michała Oczapowskiego 2, 10-719 Olsztyn, Poland

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 October 2018 in IOP Conference Series: Materials Science and Engineering
Verified
Conference Paper
Open access
PDF file
Szymon RacewiczSzymon Racewicz
Szymon Racewicz
PKPaweł Kazimierczuk
Paweł Kazimierczuk
BKBronisław Andrzej Kolator
Bronisław Andrzej Kolator
AOAndrzej Olszewski
Andrzej Olszewski
The article presents design and construction of the light two-wheeled vehicle powered by the brushless DC motor of 3 kW. The construction of the vehicle is based on a steel frame similar to the classical bicycle frame. The vehicle has been additionally equipped with pedals as an alternative driving source as well as with the standard motorcycle equipment, i.e. lamps, breaking light, horn, front disc brake, etc. The prime power source which is the BLDC motor has been installed in the rear wheel hub and is powered by a pack of 220 lithiumion power cells of 2600 mAh each. The nominal parameters of the designed power pack is 72 V and 27.5 Ah of capacity. The motor controller which can be powered by the voltage from 36 V to 95 V can deliver up to 80 A of current. It enables regenerative braking which increases an overall range of the vehicle. The article discusses also the problem of classification of such construction according to the Polish law described in the Act on the Law of Road Traffic as well as in the Regulation of the Minister of Infrastructure of 31 December 2002 on the technical conditions of vehicles and the scope of their necessary equipment. Finally, the designed construction has been tested on the MAHA LPS 3000 chassis dynamometer in order to measure mechanical and electrical parameters like maximal electric power of the motor, maximal mechanical power on the wheel, motor torque, maximal rotational speed, energy consumption, windings temperature reached, etc. These quantities will serve to further development of the designed construction.

11 October 2018 in IOP Conference Series: Materials Science and Engineering
Verified
Conference Paper
Open access
PDF file
BKBronisław Andrzej Kolator
Bronisław Andrzej Kolator
Szymon RacewiczSzymon Racewicz
Szymon Racewicz
AOA Olszewski
A Olszewski
The article presents methodology for testing the traction parameters of the lightweight two-wheeled electric vehicle on the laboratory stand and in road conditions. The tests have been carried out using MAHA LPS 3000 chassis dynamometer and the supplementary instrumentation designed and made for this purpose. The values of the drive torque and the peripheral speed of the drive wheel have been acquired using the dynamometer's measurement and registration equipment. At the same time the electric parameters of the electric motor have been measured. In order to simulate the road conditions drive on the chassis dynamometer, the set of parameters has been adjusted using measurements carried out in the real road conditions. For this purpose, during the quasi-dynamic passage of the vehicle at the constant linear speed, on the horizontal road surface and in the ambient conditions similar to those in the dynamometer laboratory the current and the voltage transmitted to the electric motor have been measured. Determining the electric power demand of the vehicle in the aforementioned conditions has enabled to adjust the chassis dynamometer parameters in order to proceed with the laboratory tests in the road conditions simulation mode.