6 May 2021 in IEEE Transactions on Electron Devices
Indium-gallium-zinc-oxide (IGZO) thin-film transistors (TFTs) gated with sputtered silicon dioxide dielectric were fabricated. Under different sputtering pressures of silicon dioxide, the device is able to produce transfer curves from clockwise hysteresis to anticlockwise hysteresis, corresponding to different operation modes and thus adding complementary performance by the same material system and device structure. In the interface trapping mode, the transistor exhibited inhibitory synaptic spiking behavior induced by positive stimuli. In the electric double-layer coupling mode, positive stimuli led to excitatory synaptic spiking behavior, while negative stimuli resulted in inhibitory synaptic spiking behavior. All the transistor and synaptic spiking behaviors are conducted within ±1 V range. Enriched functionality and ultralow operation voltage make sputtered SiO 2 -gated IGZO TFTs promising candidate for neuromorphic applications.
21 June 2019 in Nanotechnology
Here, we present theory and measurements for a bridge rectifier formed from arrays of graphene self-switching diodes (GSSDs). Despite graphene’s lack of a bandgap and high carrier concentration causing a reduced rectification ratio, the extremely high carrier mobility will allow GSSDs to work at frequencies well into the THz region. Compared with a single SSD array, the bridge rectifier structure allows for full-wave rectification of an AC signal. Here we derive an equation for the voltage output of a bridge rectifier formed from GSSDs, which predicts a quadratic relationship between output voltage and input current. This relationship is confirmed using AC and DC measurements. The fabricated rectifier is found to have a high room temperature intrinsic responsivity of at low frequency and a low noise equivalent power of
11 July 2019 in IEEE Electron Device Letters
Thin-film Schottky diodes are one of the key elements in large-area flexible electronics. In such devices, a highly uniform semiconductor film is vital for the device performance. Here, we propose a novel solution-based anodization method to form a conformal oxide semiconductor layer for Schottky diodes. The thickness of the anodized TiO 2 layer varied from 12 to 22.5 nm. The optimized Pt/TiO 2 /Ti Schottky diode demonstrated a large barrier height of 1.19 eV, an ON/OFF ratio as high as ${3.5} \times {10}^{{6}}$ at ± 2 V, and an ideality factor of 1.5. The average breakdown electric field was 5.5 MV/cm, which is higher than typical values of conventional solution processed TiO 2 . The diode with a 15-nm-thick TiO 2 layer also showed good rectification properties up to 0.7 MHz.