7 December 2020 in Thermal Engineering
The results from an analysis of the Russian market of steam-turbine machine building for various industries are reviewed, including determining the basic features of turbines for this market segment and the requirements imposed upon them. A conclusion has been made that industrial enterprises’ demand for steam turbines will persist during the fourth energy transition. The advantages in developing large consumers’ own generation of heat and power in Russia are outlined. An increase in demand for upgrading and replacement of equipment in the next decade is predicted. Exclusive projects of steam turbines for industrial generation developed at AO Ural Turbine Works (UTW) during the last few years are presented. The selection made includes equipment with an electrical power of 30, 50, or 60 MWel operating at different live steam pressures (2.9, 8.8, or 12.8 MPa) and differing in design types T, PT, PR, or R. The design and process solutions implemented to improve the efficiency of these turbine units within the scope of the individual requirements set forth by the facilities where these turbines are to operate are presented. The main characteristics are presented of the turbines designed for replacing the equipment manufactured in the 20th century without any modification to the existing foundations and overall dimensions of compartments. An approach to the development of modern steam turbine products for the market segment of industrial generation is identified. An engineering criterion for the effectiveness of a turbine unit in case of its continuous operation throughout the year is proposed to select the best equipment for specific operating conditions. The benefit from using an additional criterion at the stage of tender held by the customer for calculation of integral estimation of the annual operating expenses for purchasing electricity by the enterprise is substantiated.
30 October 2023 in Issues of Reconstructive and Plastic Surgery
September 30, 1994 in Tomsk Regional Clinical Hospital (TRCH) was open the Department of Reconstructive and Plastic Microsurgery. In 2002, after two stages of reorganization of the department into the Institute of Microsurgery, its work began to be carried out in 4 directions: medical, scientific, educational, publishing. An analysis of the medical work was carried out in term of the microneurovascular surgery development, from the Department of Reconstructive and Plastic Microsurgery of the TRCH up to the present, in the status of the Institute of Microsurgery (established on 06.02.2002). The results are showen the following main trends in the development of Reconstructive Microsurgery in Tomsk: autotransplantation of tissue on axial vessels, supermicrosurgery, nanomicrosurgery.
7 December 2020 in Thermal Engineering
On the example of the T-100-12.8 turbine, it is shown that its efficiency in winter (with a fully closed diaphragm) is significantly influenced by the state of the vacuum system and ejectors. An analysis of the effect of the vacuum in the condenser on the efficiency of the cogeneration turbine with a completely closed cogeneration diaphragm and the operation of the turbine according to the thermal schedule when the steam flow rate in the low-pressure part does not exceed 60 t/h is presented. In this case, the pressure in the condenser depends on the tightness of the turbine vacuum system, the state of the ejectors, and the water temperature at the inlet to the condenser and is determined by the characteristics of the ejector. With a completely closed cogeneration diaphragm, the pressure in the condenser does not depend on the steam and circulating water consumption nor, within certain limits, on the state of the heat exchange surface (tube fouling). The change in the turbine capacity in modes with a fully closed diaphragm depends on the deviation of the condenser vacuum from the standard value nonlinearly. At low steam pressure (low temperature of the circulating water at the inlet to the condenser), the power change is more significant than at increased pressure. Power losses increase with an increase in the steam pressure in the lower heating extraction, a decrease in the temperature of the circulating water, and an increase in air inleakage into the condenser. With the diaphragm fully closed, the standard pressure in the condenser is maintained by one ejector if the air inleakage does not exceed the standard value of 15 kg/h. When two ejectors are switched on, the standard vacuum in the condenser in this case can be maintained if the air inleakage is less than 25 kg/h. When the steam consumption in the LPP is more than 80 t/h, the change in the turbine power becomes proportional to the change in the steam pressure in the condenser.
28 July 2024 in Issues of Reconstructive and Plastic Surgery
The aim of our work was to study the syntopy and pathomorphology of excised volar ganglia. The study design involved two groups: an experimental group and a control group. The experimental group consisted of 20 patients with volar ganglion of the wrist joint who underwent treatment at the Microsurgery Research Institute clinic from October 2022 to January 2023. All patients underwent open excision of the volar ganglion under the control of 3× optical magnification. During the operation, the syntopy of the ganglion was studied in all patients, and a sample of the wrist joint capsule was taken for morphological examination, where the ganglion pedicle and the ganglion itself were attached. Anatomical material (7 specimens) served as a control a similar area of the wrist joint capsule taken from patients without wrist pathology, obtained from the pathological anatomy office. To determine the syntopy of the ganglion pedicle, intraoperative radiographic examination of the wrist joint was performed. The ganglion and the excised capsule segment were fixed in 10% neutral buffered formalin, then subjected to histological examination with hematoxylin and eosin staining. The pathomorphological picture of the excised joint capsule segment, adjacent to the ganglion pedicle, showed that the visually unchanged joint capsule consisted of coarse fibrous connective tissue with hyalinosis and areas of focal myxomatosis, with an increased number of fibrocytes and fibroblasts, as well as a small number of mononuclear elements.The assessment of the pathomorphology of the volar ganglion itself showed that it was similar to the capsule, represented by coarse fibrous connective tissue with areas of hyalinosis. The epithelial lining was absent. Numerous areas of myxomatosis with uneven mononuclear infiltration and foci with a large number of fibroblastic and histiocytoid elements were present. The capsule and the volar ganglion itself had identical histological structures.
28 July 2024 in Issues of Reconstructive and Plastic Surgery
The problems with bone healing still exist, despite the significant development of treatment methods in traumatology and orthopedics. There is a standard treatment approach with expected consolidation times of up to 6 months for diaphyseal femoral fractures. However, there are no algorithms for cases when the time for consolidation exceeds 1 year. In this article is presented the experience of treating a patient with a diaphyseal femoral fracture that had delayed consolidation.
28 October 2025 in Issues of Reconstructive and Plastic Surgery
This study extends our ongoing investigation of wrist joint ganglion, which was initiated in 2022, with preliminary findings published in 2024. The purpose of the present phase was to perform a detailed analysis of the syntopic relationships and pathomorphological features of ganglion with dorsal localization on the wrist joint. The study included 20 patients (18 women and 2 men) diagnosed with a dorsal ganglion of the wrist joint. Treatment was conducted at the clinic of the Autonomous Non-Profit Organization “Institute of Microsurgery” (Tomsk, Russia) from January 2022 to March 2023. Age of the patients ranged from 18 to 49 years, with an average of (39 ± 16) years. The pathology localization was distributed as follows: in 14 cases, the lesion was identified in the right wrist joint, and in 6 cases – in the left. All participants had an isolated form of the disease, without associated degenerative or traumatic changes in the hand. This was confirmed by clinical examinations, ultrasound diagnostics, and magnetic resonance imaging conducted during the preoperative preparation stage. Surgical intervention was performed under local infiltration anesthesia using a 1 % lidocaine solution. The ganglion was removed using an open method with threefold optical magnification. During the surgical procedure, the synoptic relationship of the ganglion was studied, and a fragment of the wrist joint capsule was collected at the site of the ganglion stalk attachment for subsequent morphological analysis. As control material, 7 samples of the wrist joint capsule were used, obtained postmortem from individuals without pathologies in this area, under the conditions of a pathological anatomy bureau. The obtained samples were fixed in 10 % neutral buffered formalin and subjected to histological examination with hematoxylin and eosin staining. The study confirms that dorsal ganglion originate from the capsule of the wrist joint in the area of the scapholunate ligament. Histological analysis of the removed capsule section, to which the ganglion stalk was attached, revealed that its structure consists of dense fibrous connective tissue with rare zones of hyalinization. Pronounced foci of myxomatous changes were also observed, accompanied by active proliferation of fibroblast-like cells and mononuclear infiltration. It was established that the joint capsule and the volar ganglion share a similar histological structure.