This paper presents a study of the interaction between high-speed airflow and the surface of a solid low-melting material in a flowing channel of a model body. Both numerical and experimental approaches are used to solve the problem, which allows one to perform a comprehensive analysis of the processes under study. Numerical simulation conditions correspond to aerodynamic tests in the experimental facility. The unsteady Reynolds-averaged Navier-Stokes (URANS) equations are used to describe a gas flow. When solving the problem, the coupled heat-transfer and turbulence are taken into account. The low-temperature gas-dynamic processes are considered, while the chemical reactions and phase transition are neglected. As a result of numerical simulations, the flow structure and regime in a flowing channel of the model are determined, as well as the pressure and temperature distributions in the near-wall region of a solid combustible material. The gas flow regime corresponds to an underexpanded jet flow with the separation of the boundary layer and the formation of the intense heat-transfer regions at the initial section of the flowing channel. According to the numerical simulation results, in aerodynamic tests with a Mach number of 6, the melting point is attained in the near-wall region of the solid combustible material (polyethylene, polyoxymethylene, and wax). Aerodynamic tests are carried out to validate the obtained results. Experimental results show that the variation in the flowing channel diameter in the thick-wall cylinder made of polyethylene and polyoxymethylene is induced by thermal expansion. In aerodynamic tests with a wax cylinder, the mass reduction and the fusion of the solid-gas interface are revealed.
1 January 2024 in Vestnik Tomskogo Gosudarstvennogo Universiteta. Matematika i Mekhanika
In this paper, the experimental dependences of static pressure and temperature on time and distance for channel flow are presented and analyzed. The choice of channel geometry is determined by the fact that a backward-facing step can be considered as a convergent-divergent diffuser, air duct, combustion chamber, etc. The experiments are carried out on a supersonic short-term aerodynamic setup with airflow at Mach numbers of 5 and 6. The obtained data are compared with the results of similar wind-tunnel tests in an axisymmetric case. For flat-channel flows, the recirculation zone occurs only behind the step. No other recirculation zones are observed due to the sufficient increase in transverse velocity along the channel. At the same time, the longitudinal velocity decreases, which leads to an increase in the static pressure. Thus, the intensity of the reflected shock waves abruptly becomes weaker, so that no other recirculation zones appear in the flow. The obtained temperature distributions in the near-wall zone at air deceleration during the flow over a backward-facing step at the considered flow velocities are found to have a minimum. The temperature then increases due to significant flow deceleration.