Yelena L. Pichugina

Yelena L. Pichugina

Auto-generated profile, based on publicly available information

Yelena L. Pichugina

CIRES, University of Colorado Boulder, Boulder, CO, USA

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2012 in Journal of Applied Meteorology and Climatology
Verified
Journal Article
Open access
YPYelena L. Pichugina
Yelena L. Pichugina
RBRobert M. Banta
Robert M. Banta
WBW. Alan Brewer
W. Alan Brewer
SSScott P. Sandberg
Scott P. Sandberg
RHR. Michael Hardesty
R. Michael Hardesty
Accurate measurement of wind speed profiles aloft in the marine boundary layer is a difficult challenge. The development of offshore wind energy requires accurate information on wind speeds above the surface at least at the levels occupied by turbine blades. Few measured data are available at these heights, and the temporal and spatial behavior of near-surface winds is often unrepresentative of that at the required heights. As a consequence, numerical model data, another potential source of information, are essentially unverified at these levels of the atmosphere. In this paper, a motion-compensated, high-resolution Doppler lidar–based wind measurement system that is capable of providing needed information on offshore winds at several heights is described. The system has been evaluated and verified in several ways. A sampling of data from the 2004 New England Air Quality Study shows the kind of analyses and information available. Examples include time–height cross sections, time series, profiles, and distributions of quantities such as winds and shear. These analyses show that there is strong spatial and temporal variability associated with the wind field in the marine boundary layer. Winds near the coast show diurnal variations, and frequent occurrences of low-level jets are evident, especially during nocturnal periods. Persistent patterns of spatial variability in the flow field that are due to coastal irregularities should be of particular concern for wind-energy planning, because they affect the representativeness of fixed-location measurements and imply that some areas would be favored for wind-energy production whereas others would not.

6 December 2016 in Wind Energy
Verified
Journal Article
Closed access
PDF file
YPY. L. Pichugina
Y. L. Pichugina
WBW. A. Brewer
W. A. Brewer
RBR. M. Banta
R. M. Banta
ACA. Choukulkar
A. Choukulkar
CCC. T. M. Clack
C. T. M. Clack
RHR. M. Hardesty
R. M. Hardesty

1 September 2024 in Journal of Renewable and Sustainable Energy
Verified
Journal Article
Open access
PDF file
PMPatrick Moriarty
Patrick Moriarty
NBNicola Bodini
Nicola Bodini
SLStefano Letizia
Stefano Letizia
AAAliza Abraham
Aliza Abraham
TATyler Ashley
Tyler Ashley
DZDaniel Zalkind
Daniel Zalkind
The American WAKE ExperimeNt (AWAKEN) is a multi-institutional field campaign focused on gathering critical observations of wind farm–atmosphere interactions. These interactions are responsible for a large portion of the uncertainty in wind plant modeling tools that are used to represent wind plant performance both prior to construction and during operation and can negatively impact wind energy profitability. The AWAKEN field campaign will provide data for validation, ultimately improving modeling and lowering these uncertainties. The field campaign is designed to address seven testable hypotheses through the analysis of the observations collected by numerous instruments at 13 ground-based locations and on five wind turbines. The location of the field campaign in Northern Oklahoma was chosen to leverage existing observational facilities operated by the U.S. Department of Energy Atmospheric Radiation Measurement program in close proximity to five operating wind plants. The vast majority of the observations from the experiment are publicly available to researchers and industry members worldwide, which the authors hope will advance the state of the science for wind plants and lead to lower cost and increased reliability of wind energy systems.

1 August 2008 in Journal of Atmospheric and Oceanic Technology
Verified
Journal Article
Open access
YPYelena L. Pichugina
Yelena L. Pichugina
STSara C. Tucker
Sara C. Tucker
RBRobert M. Banta
Robert M. Banta
WBW. Alan Brewer
W. Alan Brewer
NKNeil D. Kelley
Neil D. Kelley
RNRob K. Newsom
Rob K. Newsom
Quantitative data on turbulence variables aloft—above the region of the atmosphere conveniently measured from towers—have been an important but difficult measurement need for advancing understanding and modeling of the stable boundary layer (SBL). Vertical profiles of streamwise velocity variances obtained from NOAA’s high-resolution Doppler lidar (HRDL), which have been shown to be approximately equal to turbulence kinetic energy (TKE) for stable conditions, are a measure of the turbulence in the SBL. In the present study, the mean horizontal wind component U and variance σ2u were computed from HRDL measurements of the line-of-sight (LOS) velocity using a method described by Banta et al., which uses an elevation (vertical slice) scanning technique. The method was tested on datasets obtained during the Lamar Low-Level Jet Project (LLLJP) carried out in early September 2003, near the town of Lamar in southeastern Colorado. This paper compares U with mean wind speed obtained from sodar and sonic anemometer measurements. The results for the mean U and mean wind speed measured by sodar and in situ instruments for all nights of LLLJP show high correlation (0.71–0.97), independent of sampling strategies and averaging procedures, and correlation coefficients consistently >0.9 for four high-wind nights, when the low-level jet speeds exceeded 15 m s−1 at some time during the night. Comparison of estimates of variance, on the other hand, proved sensitive to both the spatial and temporal averaging parameters. Several series of averaging tests are described, to find the best correlation between TKE calculated from sonic anemometer data at several tower levels and lidar measurements of horizontal-velocity variance σ2u. Because of the nonstationarity of the SBL data, the best results were obtained when the velocity data were first averaged over intervals of 1 min, and then further averaged over 3–15 consecutive 1-min intervals, with best results for the 10- and 15-min averaging periods. For these cases, correlation coefficients exceeded 0.9. As a part of the analysis, Eulerian integral time scales (τ) were estimated for the four high-wind nights. Time series of τ through each night indicated erratic behavior consistent with the nonstationarity. Histograms of τ showed a mode at 4–5 s, but frequent occurrences of larger τ values, mostly between 10 and 100 s.

1 January 2010 in Journal of Applied Meteorology and Climatology
Verified
Journal Article
Open access
YPYelena L. Pichugina
Yelena L. Pichugina
RBRobert M. Banta
Robert M. Banta
The depth h of the stable boundary layer (SBL) has long been an elusive measurement. In this diagnostic study the use of high-quality, high-resolution (Δz = 10 m) vertical profile data of the mean wind U(z) and streamwise variance σu2(z) is investigated to see whether mean-profile features alone can be equated with h. Three mean-profile diagnostics are identified: hJ, the height of maximum low-level-jet (LLJ) wind speed U in the SBL; h1, the height of the first zero crossing or minimum absolute value of the magnitude of the shear ∂U/∂z profile above the surface; and h2, the minimum in the curvature ∂2U/∂z2 profile. Boundary layer BL here is defined as the surface-based layer of significant turbulence, so the top of the BL was determined as the first significant minimum in the σu2(z) profile, designated as hσ. The height hσ was taken as a reference against which the three mean-profile diagnostics were tested. Mean-wind profiles smooth enough to calculate second derivatives were obtained by averaging high-resolution Doppler lidar profile data, taken during two nighttime field programs in the Great Plains, over 10-min intervals. Nights are chosen for study when the maximum wind speed in the lowest 200 m exceeded 5 m s−1 (i.e., weak-wind, very stable BLs were excluded). To evaluate the three diagnostics, data from the 14-night sample were divided into three profile shapes: Type I, a traditional LLJ structure with a distinct maximum or “nose,” Type II, a “flat” structure with constant wind speed over a significant depth, and Type III, having a layered structure to the shear and turbulence in the lower levels. For Type I profiles, the height of the jet nose hJ, which coincided with h1 and h2 in this case, agreed with the reference SBL depth to within 5%. The study had two major results: 1) among the mean-profile diagnostics for h, the curvature depth h2 gave the best results; for the entire sample, h2 agreed with hσ to within 12%; 2) considering the profile shapes, the layered Type III profiles gave the most problems. When these profiles could be identified and eliminated from the sample, regression and error statistics improved significantly: mean relative errors of 8% for hJ and h1, and errors of <5% for h2, were found for the sample of only Type I and II profiles.

7 January 2021 in Wind Energy Science
Verified
Journal Article
Open access
PDF file
Caroline DraxlCaroline Draxl
Caroline Draxl
RWRochelle P. Worsnop
Rochelle P. Worsnop
GXGeng Xia
Geng Xia
YPYelena Pichugina
Yelena Pichugina
DCDuli Chand
Duli Chand
LBLarry Berg
Larry Berg
Mountains can modify the weather downstream of the terrain. In particular, when stably stratified air ascends a mountain barrier, buoyancy perturbations develop. These perturbations can trigger mountain waves downstream of the mountains that can reach deep into the atmospheric boundary layer where wind turbines operate. Several such cases of mountain waves occurred during the Second Wind Forecast Improvement Project (WFIP2) in the Columbia River basin in the lee of the Cascade Range bounding the states of Washington and Oregon in the Pacific Northwest of the United States. Signals from the mountain waves appear in boundary layer sodar and lidar observations as well as in nacelle wind speeds and power observations from wind plants. Weather Research and Forecasting (WRF) model simulations also produce mountain waves and are compared to satellite, lidar, and sodar observations. Simulated mountain wave wavelengths and wave propagation speeds (group velocities) are analyzed using the fast Fourier transform. We found that not all mountain waves exhibit the same speed and conclude that the speed of propagation, magnitudes of wind speeds, or wavelengths are important parameters for forecasters to recognize the risk for mountain waves and associated large drops or surges in power. When analyzing wind farm power output and nacelle wind speeds, we found that even small oscillations in wind speed caused by mountain waves can induce oscillations between full-rated power of a wind farm and half of the power output, depending on the position of the mountain wave's crests and troughs. For the wind plant analyzed in this paper, mountain-wave-induced fluctuations translate to approximately 11 % of the total wind farm output being influenced by mountain waves. Oscillations in measured wind speeds agree well with WRF simulations in timing and magnitude. We conclude that mountain waves can impact wind turbine and wind farm power output and, therefore, should be considered in complex terrain when designing, building, and forecasting for wind farms.