25 August 2009 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
In recent high-density VLSIs, soft errors, particularly single event upsets (SEUs), frequently occur during system operation. In addition, the occurrence of delay faults caused by manufacturing defects is a significant problem. Thus, SEU tolerant design and delay fault testing are of increasing significance. This paper presents two types of SEU tolerant flip-flops (FFs). The proposed FFs tolerate SEUs caused by particles striking feedback loops in the FFs. Moreover, the proposed FFs allow enhanced scan delay fault testing. The proposed FFs are master-slave FFs, and the slave latches are constructed by modifying existing SEU tolerant latches, namely, SEH latches. The two proposed FFs tolerate particles with charges of 370 fC and of 369 fC or lower, whereas an existing SEU tolerant enhanced scan FF, called an ESFF-SEC, tolerates those of 431 fC or lower. Furthermore, the areas of the proposed FFs are 23.1% and 20.5% smaller than that of the ESFF-SEC. The CK-Q delay times are 44.4% and 41.1% shorter than that of the ESFF-SEC. Moreover, the average power consumptions of the proposed FFs during system operations are 55.6% and 53.3% lower than that of the ESFF-SEC.
4 January 2023 in IEEE Transactions on Antennas and Propagation
Recently, unmanned aerial vehicles onboard synthetic aperture radar (UAV-SAR) have been developed by many institutions to provide high-resolution, real-time data acquisition and local emergency observation. The SAR system remains the issue to realize the system with the high resolution, lightweight, minimalized payload, power efficiency, high altitude operation, extreme environment, long-duration flight, and full polarimetric mode. For this purpose, our research group plans to develop the X-band circularly polarized UAV SAR for disaster and environmental monitoring using the 25 kg payload of the UAV. The SAR system requires a broadband antenna and full circular polarization for precise observations. The antenna for the SAR systems requires a small size, lightweight, high gain, broadband for chirp pulse, and good antenna isolation and axial ratio (AR). For this purpose, we proposed the 4×4 ax-shaped radiator array antenna. The proposed antenna was simulated, fabricated, and measured in an anechoic chamber. Furthermore, the indoor polarimetric scattering SAR experiment was conducted using canonical targets to investigate the polarimetric SAR capability of the system with the proposed antenna. The result proves the performance of circularly polarized SAR.
4 January 2008 in Journal of Electronic Testing
14 January 2014 in IEEE Transactions on Device and Materials Reliability
This paper presents a concurrent error detection (CED) scheme for orthogonal Latin square (OLS) parallel decoders. Different from a CED scheme found in the technical literature that protects only the syndrome generator, the proposed CED scheme protects the whole OLS decoder for single stuck-at faults. This paper presents the detailed design and analysis of the proposed CED scheme and shows that it is strongly fault secured for single stuck-at faults. Extensive simulation results are also provided; different figures of merit such as area, power dissipation, gate depth, and coverage are assessed. It is shown that the proposed decoder designs for ( n, k) t-bit error correcting OLS codes (k = 16 ...256; t = 2 ...5) have reasonable overhead; for example, the average area overhead of the proposed CED is 35.5 (23.6) % compared with an OLS decoder with no CED (i.e., the previously reported CED scheme). However, the most significant advantage of the proposed scheme is that it achieves 100% fault coverage for the whole CED circuit, thus providing a very efficient and fully fault-tolerant implementation. The proposed CED is applicable to both binary and nonbinary OLS codes; the CED for a nonbinary OLS decoder achieves comparable or better results than a binary OLS decoder. Moreover, simulation shows that the proposed CED scheme is better than double modular redundancy.
1 October 2020 in IEICE Transactions on Information and Systems
The recent development of semiconductor technology has led to downsized, large-scaled and low-power VLSI systems. However, the incidence of soft errors has increased. Soft errors are temporary events caused by striking of a-rays and high energy neutron radiation. Since the scale of VLSI has become smaller in recent development, it is necessary to consider the occurrence of not only single node upset (SNU) but also double node upset (DNU). The existing High-performance, Low-cost, and DNU Tolerant Latch design (HLDTL) does not completely tolerate DNU. This paper presents a new design of a DNU tolerant latch to resolve this issue by adding some transistors to the HLDTL latch.
3 November 2022 in IEEE Access
With advancements in machine learning technology, networks are becoming increasingly complex, and the extent of the computation involved is increasing. Consequently, the computation time and power consumption of the learning process are increased. The error tolerance of neural networks has attracted attention as an approach to solving this problem. Because neural networks can tolerate small errors, it is possible to reduce the calculation speed and power consumption at the expense of accuracy. In this study, we propose a method to reduce the power consumption of the circuit by lowering the operating voltage of the static random-access memory (SRAM) that is utilized to store the weights. In the proposed method, using two different operating voltages of SRAM, we used different bit error rates (BERs) for error-tolerant and non-error-tolerant. We demonstrated the relationship between the BER and recognition rate, and the appropriate combination of the BER and circuit configuration that maintains a high recognition rate.