1 April 2017 in Geotextiles and Geomembranes
1 February 2018 in Geosynthetics International
Rigid piles are used to reinforce soft soil foundations and thus increase embankment stability. This technique is improved by placing one or more geosynthetic reinforcement (GR) layers inside or at the base of the embankment. A series of 33 small scale models were tested using a geotechnical centrifuge. Soft soil settlement was imposed by the downward displacement of a tray. First, a series of models were prepared to examine how the load transmitted to the pile network increased with the embankment thickness. Using the same configuration, two identical models were prepared to successively test two different types of GR (geosynthetic reinforcement). Another approach was used to study how the external surcharges applied on the embankment affect load transfer. The results showed that, compared to the piled embankment, the load transfer increased for the case of the geosynthetic-reinforced pile-supported embankment (GRPSE) due to the membrane effect. The membrane effect is higher when the GR is stiff and its vertical distance from the pile is reduced. Numerical modelling reveals that, when another GR layer is added, the second GR has an effect only if punching is sufficient. However, the second layer did not reduce embankment settlement.
1 October 2014 in Geotextiles and Geomembranes
1 February 2013 in Geotextiles and Geomembranes
1 February 2014 in Geosynthetics International
The soil reinforcement method, which consists of placing a granular mattress above a set of rigid inclusions, is used to transfer part of the surface load to the piles through arching. The addition of an extensible geosynthetic layer at the base of the mattress increases load transfer. A small-scale centrifuge model, the mobile tray device, is used to simulate the foundation behaviour by modelling soft soil settlement between the inclusions. A parametric study was conducted to examine the influence of the mattress thickness and of the pile spacing. The different test configurations are compared with regard to the stress transmitted to soft soil, to differential settlement and to the efficiency of load transfer. With thicker mattresses and/or closer pile meshing, load transfer increases and surface settlements are reduced. Geosynthetic maximum experimental and analytical deflections are also examined. For the analytical study, conducted using the EBGEO German standard, three different distributions of the vertical stress applied to the geosynthetic layer are compared: uniform, triangular and inverse triangular. All three scenario results fall within the range of the experimental results. The inverse triangular distribution reveals some deflection values that were lower than the uniform one. The triangular distribution gives the highest deflection values.
1 December 2016 in Journal of Geotechnical and Geoenvironmental Engineering
Measured loads in centrifuge tests on piled embankments were compared with values calculated by three analytical arching models. The Zaeske and Van Eekelen models use sets of arches that give the direction of the load transfer, and result in an increasing load on the soft soil with increasing embankment thickness or surcharge load, which matches the measurements. The Svanø model, however, assumes that the load on the soft soil remains constant with increasing embankment thickness or surcharge load, thereby being transferred directly to the piles. Therefore, the Zaeske and Van Eekelen models match the measurements better than the Svanø model. The Van Eekelen model slightly overestimates the pile efficiency for relatively thin embankments, but matches the measurements better than the Zaeske model for increasing embankment thickness or surcharge load.