1 February 2018 in Construction and Building Materials
1 October 2016 in Construction and Building Materials
9 February 2017 in Journal of Adhesion Science and Technology
The purpose of this study is firstly to investigate the effect of various treatments on the chemical and morphological properties of the fibers of two xerophyte plants (Doum ‘Chamaerops humilis’ and Diss ‘Ampelodesmos mauritanicus’), in order to improve the adhesion between fibers and cement matrix, secondly the effect of increasing inclusion rates of these two fibers on the physical, mechanical and thermal properties of cementitious composites. Obtainable results by infrared spectroscopy, X-ray diffraction and scanning electron microscopy revealed that the alkaline treatments of the Doum and Diss fibers with 1 and 3% NaOH for 30 min at room temperature resulted in an optimal improvement of the crystallinity index and alter the characteristics of the surface topography. The reinforcement of mortars with these two fibers caused a decrease in their bulk density and consequently the compressive strength, as well as an increase in their porosity and thus their capacity of water absorption. Moreover, the mortars reinforced with 2% of treated Diss fibers and 1.5% of treated Doum fibers show the high flexural strengths. Also, thermal conductivity measurements were carried out for different drying durations to assess the effect of water content on the thermal properties. Thermogravimetric Analysis coupled with differential scanning calorimetry are also performed to study the degradation and mass loss of composites at high temperature. The results reveal that the incorporation of these fibers reduces the thermal conductivity and increases the heat absorption of the composites.
1 September 2020 in Construction and Building Materials
1 April 2015 in Applied Thermal Engineering
Thermogravimetric analyzer coupled to a mass spectrometer (TGA-MS) was used to study the thermochemical behavior of eight samples. Two varieties of straw (wheat and barley) and two others of binder (lime and plaster) have employed to design four composites. These composites can be considered as innovative insulation materials for buildings. The thermal degradation of the different specimens was studied from a temperature of 50 to 1000ºC using increased temperature of 20ºC/min. This thermal degradation is an important element to evaluate the fire behavior and predict the evolution of smoke emitted during an accidental fire for building application. Using MS analyzer, the ion currents evolutions of 16 molecule groups (shared by a m/z ratio) were followed as functions of temperature. TG curves show that the thermal decomposition of composite samples is more complex (3-4 mass loss steps) than the one of the basic materials (1-2 mass loss stages) and seems to be mostly affected by the binder nature. The highest amount of gas in pyrolysis products is associated to m/z=28 ratio and presents more than two thirds of the total quantity. The kinetic parameters were evaluated for the more important mass loss of each sample and their values are in the ranges of 8.29-64.86 kJ/mol, 0.4-3.36 and 1.78 x 10^3 -1.63 x 10^7 min^-1 for respectively the activation energy, the reaction order and the pre-exponential factor.Peer ReviewedPostprint (author's final draft