Toyoaki Eguchi

Toyoaki Eguchi

Auto-generated profile, based on publicly available information

Toyoaki Eguchi

Department of Chemistry, Faculty of Science and Technology, Keio University, 3-14-1 Hiyoshi, Kohoku-ku, Yokohama 223-8522, Japan

Research Focus & Metrics

Academic Career Length

33Years (1994-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 October 2008 in Physical Review Letters
Verified
Journal Article
Closed access
PDF file
TNTakahiro Nishio
Takahiro Nishio
TAToshu An
Toshu An
ANAtsushi Nomura
Atsushi Nomura
KMKousuke Miyachi
Kousuke Miyachi
TEToyoaki Eguchi
Toyoaki Eguchi
YHYukio Hasegawa
Yukio Hasegawa
Superconductivity of nanosized Pb-island structures whose radius is 0.8 to 2.5 times their coherence length was studied under magnetic fields using low-temperature scanning tunneling microscopy and spectroscopy. Spatial profiles of superconductivity were obtained by conductance measurements at zero-bias voltage. Critical magnetic fields for vortex penetration and expulsion and for superconductivity breaking were measured for each island. The critical fields depending on the lateral size of the islands and existence of the minimum lateral size for vortex formation were observed.

6 September 2011 in Physical Review B
Verified
Journal Article
Closed access
Franz GiessiblFranz Giessibl
Franz Giessibl
FPFlorian Pielmeier
Florian Pielmeier
TEToyoaki Eguchi
Toyoaki Eguchi
TAToshu An
Toshu An
YHYukio Hasegawa
Yukio Hasegawa
The force sensor is key to the performance of atomic force microscopy (AFM). Nowadays, most atomic force microscopes use micromachined force sensors made from silicon, but piezoelectric quartz sensors are being applied at an increasing rate, mainly in vacuum. These self-sensing force sensors allow a relatively easy upgrade of a scanning tunneling microscope to a combined scanning tunneling/atomic force microscope. Two fundamentally different types of quartz sensors have achieved atomic resolution: the ``needle sensor,'' which is based on a length-extensional resonator, and the ``qPlus sensor,'' which is based on a tuning fork. Here, we calculate and measure the noise characteristics of these sensors. We find four noise sources: deflection detector noise, thermal noise, oscillator noise, and thermal drift noise. We calculate the effect of these noise sources as a factor of sensor stiffness, bandwidth, and oscillation amplitude. We find that for self-sensing quartz sensors, the deflection detector noise is independent of sensor stiffness, while the remaining three noise sources increase strongly with sensor stiffness. Deflection detector noise increases with bandwidth to the power of 1.5, while thermal noise and oscillator noise are proportional to the square root of the bandwidth. Thermal drift noise, however, is inversely proportional to bandwidth. The first three noise sources are inversely proportional to amplitude while thermal drift noise is independent of the amplitude. Thus, we show that the earlier finding that quoted an optimal signal-to-noise ratio for oscillation amplitudes similar to the range of the forces is still correct when considering all four frequency noise contributions. Finally, we suggest how the signal-to-noise ratio of the sensors can be improved further, we briefly discuss the challenges of mounting tips, and we compare the noise performance of self-sensing quartz sensors and optically detected Si cantilevers.

10 December 2002 in Physical Review Letters
Verified
Journal Article
Closed access
PDF file
TEToyoaki Eguchi
Toyoaki Eguchi
YHY. Hasegawa
Y. Hasegawa
Observation of the rest-atom layer of the Si(111)−(7×7) surface is performed by atomic force microscopy. By detecting the force due to the single chemical covalent bond formed between the tip and the sample surface, individual atoms on the layer were clearly resolved. Unprecedented high spatial resolution was achieved by setting the detection force at a small value and by reducing background forces due to the long-range interactions with the small oscillation amplitude of the cantilever and sharp probe tip.

22 January 2004 in Nanotechnology
Verified
Journal Article
Closed access
LNL Nony
L Nony
RBR Bennewitz
R Bennewitz
OPO Pfeiffer
O Pfeiffer
Enrico GneccoEnrico Gnecco
Enrico Gnecco
ABA Baratoff
A Baratoff
CJC Joachim
C Joachim
The adsorption of two kinds of porphyrin (Cu-TBPP) and perylene (PTCDA) derived organic molecules deposited on KBr and Al2O3 surfaces has been studied by non-contact force microscopy in ultra-high vacuum, our goal being the assembly of ordered molecular arrangements on insulating surfaces at room temperature. On a Cu(100) surface, well ordered islands of Cu-TBPP molecules were successfully imaged. On KBr and Al2O3 surfaces, it was found that the same molecules aggregate in small clusters at step edges, rather than forming ordered monolayers. First measurements with PTCDA on KBr show that nanometre-scale rectangular pits in the surface can act as traps to confine small molecular assemblies.

20 December 2004 in Physical Review Letters
Verified
Journal Article
Closed access
PDF file
TET. Eguchi
T. Eguchi
YFY. Fujikawa
Y. Fujikawa
KAK. Akiyama
K. Akiyama
TAT. An
T. An
MOM. Ono
M. Ono
YHY. Hasegawa
Y. Hasegawa
High-resolution noncontact atomic force microscope (AFM) images were successfully taken on the Ge(105)−(1×2) structure formed on the Si(105) substrate and revealed all dangling bonds of the surface regardless of their electronic situation, surpassing scanning tunneling microscopy, whose images strongly deviated from the atomic structure by the electronic states involved. An atomically resolved electrostatic potential profile by a Kelvin-probe method with AFM shows potential variations among the dangling bond states, directly observing a charge transfer between them. These results clearly demonstrate that high-resolution noncontact AFM with a Kelvin-probe method is an ideal tool for analysis of atomic structures and electronic properties of surfaces.

7 October 2014 in Nanoscale
Verified
Journal Article
Open access
PDF file
MNMasato Nakaya
Masato Nakaya
TITakeshi Iwasa
Takeshi Iwasa
HTHironori Tsunoyama
Hironori Tsunoyama
TEToyoaki Eguchi
Toyoaki Eguchi
ANAtsushi Nakajima
Atsushi Nakajima
The controlled assembly of superatomic nanocluster ions synthesized in the gas phase is a key technology for constructing a novel series of functional nanomaterials. However, it is generally difficult to immobilize them onto a conductive surface while maintaining their original properties owing to undesirable modifications of their geometry and charge state. In this study, it has been shown that this difficulty can be overcome by controlling the donor–acceptor interaction between nanoclusters and surfaces. Cations of Ta-atom-encapsulated Si16 cage nanoclusters (Ta@Si16) behaving as rare-gas-like superatoms are synthesized in the gas phase and deposited on conductive surfaces terminated with acceptor-like C60 and donor-like α-sexithiophene (6T) molecules. Scanning tunneling microscopy and spectroscopy have demonstrated that Ta@Si16 cations can be densely immobilized onto C60-terminated surfaces while retaining their cage shape and positive charge, which is realized by creating binary charge transfer complexes (Ta@Si16 +–C60 −) on the surfaces. The Ta@Si16 nanoclusters exhibit excellent thermal stability on C60-teminated surfaces similar to those in the gas phase, whereas the nanoclusters destabilize at room temperature on 6T-terminated surfaces owing to the loss of electronic closure via a change in the charge state.