Shuhong Li

Shuhong Li

Auto-generated profile, based on publicly available information

Shuhong Li

School of Energy and Environment, Southeast University, Nanjing 210000, China

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2015 in Energies
Verified
Journal Article
Open access
PDF file
WYWenchao Yang
Wenchao Yang
SLShuhong Li
Shuhong Li
XLXianliang Li
Xianliang Li
YLYuanyuan Liang
Yuanyuan Liang
XZXiaosong Zhang
Xiaosong Zhang
Cryogenic CO2 capture is considered as a promising CO2 capture method due to its energy saving and environmental friendliness. The phase equilibrium analysis of CO2-mixtures at low temperature is crucial for the design and operation of a cryogenic system because it plays an important role in analysis of recovery and purity of the captured CO2. After removal of water and toxic gas, the main components in typical boiler gases are N2/CO2. Therefore, this paper evaluates the reliabilities of different cubic equations of state (EOS) and mixing rules for N2/CO2. The results show that Peng-Robinson (PR) and Soave-Redlich-Kwong (SRK) fit the experimental data well, PR combined with the van der Waals (vdW) mixing rule is more accurate than the other models. With temperature decrease, the accuracy of the model improves and the deviation of the N2 vapor fraction is 0.43% at 220 K. Based on the selected calculation model, the thermodynamic properties of N2/CO2 at low temperature are analyzed. According to the results, a new liquefaction combined with a desublimation system is proposed. The total recovery and purity of CO2 production of the new system are satisfactory enough for engineering applications. Additionally, the total energy required by the new system to capture the CO2 is about 3.108 MJ·kg−1 CO2, which appears to be at least 9% lower than desublimation separation when the initial concentration of CO2 is 40%.

16 February 2017 in Applied Sciences
Verified
Journal Article
Open access
PDF file
NDNannan Dai
Nannan Dai
XXXinyi Xu
Xinyi Xu
SLShuhong Li
Shuhong Li
ZZZheng Zhang
Zheng Zhang
A hybrid photovoltaic solar assisted loop heat pipe/heat pump (PV-SALHP/HP) water heater system has been developed and numerically studied. The system is the combination of loop heat pipe (LHP) mode and heat pump (HP) mode, and the two modes can be run separately or compositely according to the weather conditions. The performances of independent heat pump (HP) mode and hybrid loop heat pipe/heat pump (LHP/HP) mode were simulated and compared. Simulation results showed that on typical sunny days in spring or autumn, using LHP/HP mode could save 40.6% power consumption than HP mode. In addition, the optimal switchover from LHP mode to HP mode was analyzed in different weather conditions for energy saving and the all-year round operating performances of the system were also simulated. The simulation results showed that hybrid LHP/HP mode should be utilized to save electricity on sunny days from March to November and the system can rely on LHP mode alone without any power consumption in July and August. When solar radiation and ambient temperature are low in winter, HP mode should be used

19 March 2012 in International Journal of Low-Carbon Technologies
Verified
Journal Article
Open access
PDF file
SLShuhong Li
Shuhong Li
YLYang Li
Yang Li
XZXiaosong Zhang
Xiaosong Zhang
CWCai Wen
Cai Wen
Water thermal stratification exists in the discharging process of solar storage tanks, and a high efficiency of thermal stratification can greatly improve the discharging performance of solar tanks. The water tank with dimensions of 0.8 m (height) × 0.4 m (width) × 0.4 m (length) and three kinds of inlet structures were investigated in this study. The inlets included a perforated inlet, slotted inlet and direct inlet. The discharging performance of the tank was studied by presenting some compared experiments. The dimensionless discharging time was defined to analyze the temperature change of top-layer and inter-layer of water. Quantitative analysis and comparison based on the effective discharging efficiency and carbon reduction in the tank with different inlet structures were carried out in this study. The results indicated that the perforated inlet and slotted inlet improved the performance of thermal stratification effectively. The effective discharging efficiency of the perforated inlet structure was 21% higher than that of a direct inlet with the flow rate of 5 l/min and the gap increased to 40% when the flow rate increased to 15 l/min. The application of the perforated inlet tank in the discharging process in all solar water heaters in China can provide a CO2 reduction of 5.39 × 104t compared with the direct inlet tank.

5 September 2013 in International Journal of Low-Carbon Technologies
Verified
Journal Article
Open access
PDF file
SLShuhong Li
Shuhong Li
JDJie Ding
Jie Ding
XZXiaosong Zhang
Xiaosong Zhang
DCDeyuan Cheng
Deyuan Cheng
XHXinyu Hu
Xinyu Hu
XLXianliang Li
Xianliang Li
A new CO2 cryogenic capture and liquefaction system has been proposed previously in order to separate CO2 from exhausted gases and make it as a resource for industry. This system combines CO2 cryogenic capture with N2/O2 separation together. Its energy consumption is lower than the traditional amine solution capture process as theoretical analysis. In this study, the simulation of the proposed system with several improvements was carried out aiming to reduce the energy consumption further. Many heat exchangers were introduced and the heat exchanger arrangements were optimized to recycle the refrigeration capacity from the returned N2 after the N2/O2 separation. The discharge pressure of mixture gas from the compressor was reduced from 10 to 3.493 MPa. The simulation results showed that the compression work could be greatly reduced and the energy consumption of CO2 capture in this new system after these improvements reached 2.884 GJ/ton CO2. The new system is promising because not only liquid or solid CO2 could be produced but also N2 and O2 could be separated.