19 August 2019 in IEEE Transactions on Microwave Theory and Techniques
This article studies the processing principles, implementation challenges, and performance of orthogonal frequency-division multiplexing (OFDM)-based radars, with particular focus on the fourth-generation Long-Term Evolution (LTE) and fifth-generation (5G) New Radio (NR) mobile networks' base stations and their utilization for radar/sensing purposes. First, we address the problem stemming from the unused subcarriers within the LTE and NR transmit signal passbands and their impact on frequency-domain radar processing. In particular, we formulate and adopt a computationally efficient interpolation approach to mitigate the effects of such empty subcarriers in the radar processing. We evaluate the target detection and the corresponding range and velocity estimation performance through computer simulations and show that high-quality target detection as well as high-precision range and velocity estimation can be achieved. In particular, 5G NR waveforms, through their impressive channel bandwidths and configurable subcarrier spacing, are shown to provide very good radar/sensing performance. Then, a fundamental implementation challenge of transmitter-receiver (TX-RX) isolation in OFDM radars is addressed, with specific emphasis on shared-antenna cases, where the TX-RX isolation challenges are the largest. It is confirmed that from the OFDM radar processing perspective, limited TX-RX isolation is primarily a concern in the detection of static targets, while moving targets are inherently more robust to transmitter self-interference (SI). Properly tailored analog/RF and digital SI cancellation solutions for OFDM radars are also described and implemented and shown through RF measurements to be key technical ingredients for practical deployments, particularly from static and slowly moving targets' point of view.
12 June 2014 in IEEE Journal on Selected Areas in Communications
This paper addresses the modeling and cancellation of self-interference in full-duplex direct-conversion radio transceivers, operating under practical imperfect radio frequency (RF) components. First, detailed self-interference signal modeling is carried out, taking into account the most important RF imperfections, namely, transmitter power amplifier nonlinear distortion as well as transmitter and receiver IQ mixer amplitude and phase imbalances. The analysis shows that after realistic antenna isolation and RF cancellation, the dominant self-interference waveform at the receiver digital baseband can be modeled through a widely linear transformation of the original transmit data, opposed to classical purely linear models. Such widely linear self-interference waveform is physically stemming from the transmitter and receiver IQ imaging and cannot be efficiently suppressed by classical linear digital cancellation. Motivated by this, novel widely linear digital self-interference cancellation processing is then proposed and formulated, combined with efficient parameter estimation methods. Extensive simulation results demonstrate that the proposed widely linear cancellation processing clearly outperforms the existing linear solutions, hence enabling the use of practical low-cost RF front ends utilizing IQ mixing in full-duplex transceivers.
2 April 2014 in IEEE Transactions on Wireless Communications
Despite the intensive recent research on wireless single-channel full-duplex communications, relatively little is known about the transceiver chain nonidealities of full-duplex devices. In this paper, the effect of nonlinear distortion occurring in the transmitter power amplifier (PA) and the receiver chain is analyzed, beside the dynamic range requirements of analog-to-digital converters (ADCs). This is done with detailed system calculations, which combine the properties of the individual electronics components to jointly model the complete transceiver chain, including self-interference cancellation. They also quantify the decrease in the dynamic range for the signal of interest caused by self-interference at the analog-to-digital interface. Using these system calculations, we provide comprehensive numerical results for typical transceiver parameters. The analytical results are also confirmed with full waveform simulations. We observe that the nonlinear distortion produced by the transmitter PA is a significant issue in a full-duplex transceiver and, when using cheaper and less linear components, also the receiver chain nonlinearities become considerable. It is also shown that, with digitally intensive self-interference cancellation, the quantization noise of the ADCs is another significant problem.
14 May 2015 in IEEE Communications Magazine
EAEmilio Antonio-Rodriguez
SVSathya Venkatasubramanian
Sathya Venkatasubramanian
+5
In-band full-duplex relays transmit and receive simultaneously at the same center frequency, hence offering enhanced spectral efficiency for relay deployment. In order to deploy such full-duplex relays, it is necessary to efficiently mitigate the inherent self-interference stemming from the strong transmit signal coupling to the sensitive receive chain. In this article, we present novel state-of-the-art antenna solutions as well as digital self-interference cancellation algorithms for compact MIMO full-duplex relays, specifically targeted for reduced-cost deployments in local area networks. The presented antenna design builds on resonant wavetraps and is shown to provide passive isolations on the order of 60-70 dB. We also discuss and present advanced digital cancellation solutions, beyond classical linear processing, specifically tailored against nonlinear distortion of the power amplifier when operating close to saturation. Measured results from a complete demonstrator system, integrating antennas, RF cancellation, and nonlinear digital cancellation, are also presented, evidencing close to 100 dB of overall self-interference suppression. The reported results indicate that building and deploying compact full-duplex MIMO relays is already technologically feasible.
15 July 2008 in IEEE Transactions on Vehicular Technology
Communication receivers that utilize I/Q downconversion are troubled by amplitude and phase mismatches between the analog I and Q branches. These mismatches are unavoidable in practice and reduce the obtainable image frequency attenuation to the 20-40-dB range in practical receivers. In wideband multichannel receivers, where the overall bandwidths are in the range of several megahertz and the incoming carriers located at each other's mirror frequencies have a high dynamic range, the image attenuation of the analog front-end (FE) alone is clearly insufficient. In this paper, two novel blind low-complexity I/Q imbalance compensation techniques are proposed and analyzed to digitally enhance the analog FE image attenuation in wideband direct-conversion receivers. The proposed algorithms are grounded on the concept of circular or proper complex random signals, and they are, by design, able to handle the often overlooked yet increasingly important case of frequency-dependent I/Q mismatches. The first technique is an iterative one, stemming from adaptive filtering principles, whereas the second one is a moment-estimation-based block method. The performance of the algorithms is evaluated through computer simulations, as well as real-world laboratory signal measurement examples in practical multicarrier receiver cases. Based on the obtained results, the proposed compensation techniques can provide very good compensation performance with low computational resources and are robust in the face of different imbalance levels and dynamics of the received signals, as well as many other crucial practical aspects such as the effects of the communications channel and carrier synchronization.
16 September 2016 in IEEE Communications Magazine
In this article, we address the challenges of transmitter-receiver isolation in mobile full-duplex devices, building on shared-antenna-based transceiver architecture. First, self-adaptive analog RF cancellation circuitry is required, since the ability to track time-varying self-interference coupling characteristics is of utmost importance in mobile devices. In addition, novel adaptive nonlinear DSP methods are also required for final self-interference suppression at digital baseband, since mobile-scale devices typically operate under highly nonlinear low-cost RF components. In addition to describing the above kind of advanced circuit and signal processing solutions, comprehensive RF measurement results from a complete demonstrator implementation are also provided, evidencing beyond 40 dB of active RF cancellation over an 80 MHz waveform bandwidth with a highly nonlinear transmitter power amplifier. Measured examples also demonstrate the good self-healing characteristics of the developed control loop against fast changes in the coupling channel. Furthermore, when complemented by nonlinear digital cancellation processing, the residual self-interference level is pushed down to the noise floor of the demonstration system, despite the harsh nonlinear nature of the self-interference. These findings indicate that deploying the full-duplex principle can indeed also be feasible in mobile devices, and thus be one potential technology in, for example, 5G and beyond radio systems.