Metal‐supported solid oxide fuel cells (MS‐SOFCs) have been fabricated by applying phase‐inversion tape‐casting and atmospheric plasma spraying (APS). The effect of the binder amount of the phase‐inversion slurries on the microstructure development of the 430L stainless steel metal support was investigated. The pore structures, the viscosity of the slurry, porosity and permeability of the as‐prepared metal supports are significantly influenced by the amount of the binder. NiO–scandia‐stabilized zirconia (ScSZ) anode, ScSZ electrolyte and La 0.6 Sr 0.4 Co 0.2 Fe 0.8 O 3−δ (LSCF) cathode layers were consecutively deposited on the metal support with an ideal microstructure by APS process. The effect of plasma power of the APS on the microstructure of the electrolyte and cathode was investigated. A dense electrolyte layer and a porous cathode layer were successfully obtained at 40 and 6 kW of the APS plasma power, respectively. MS‐SOFCs, with a cell configuration of 430L/Ni‐ScSZ/ScSZ/LSCF, achieved a maximum cell power density of 1079 mW cm −2 at 700°C using humidified H 2 as fuel and ambient air as oxidant. The corresponding ohmic resistance and total resistance of MS‐SOFCs was 0.14 and 0.32 Ω cm 2 , respectively. This work demonstrates the feasibility of fabricating high‐performance MS‐SOFCs with economical and scalable techniques.
A conformal layer of CeO 2 on the surface of LSCF can be obtained using CVD. The fine-tuned CeO 2 /LSCF heterointerface and the suppressed Sr-segregation resulted in the improved electrochemical performance and enhanced Cr-tolerance of LSCF cathode.
3 September 2024 in Journal of Materials Chemistry A
La0.6Sr0.4Co0.2Fe0.8O3−δ (LSCF) is the state-of-the-art air electrode material for solid oxide electrochemical cells using oxide-ion electrolytes, yet its application in proton ceramic electrochemical cells (PCCs) remains limited, mainly attributed to its instability under operating conditions of high temperature and high humidity. To address this issue, coating a PrCoO3−δ (PCO) catalyst onto the LSCF scaffold has been evaluated in this study. The introduction of the PCO coating not only enhances the LSCF electrode's electrochemical performance but also significantly improves its steam tolerance by preventing direct contact between steam and LSCF. A PCC single cell with the PCO-coated LSCF air electrode exhibited a peak power density of 1.14 W cm−2 in fuel cell mode and a current density of 2.04 A cm−2 at an applied voltage of 1.3 V in electrolysis cell mode at 650 °C. Furthermore, single cells demonstrated excellent durability under operating conditions of high temperature and high humidity, maintaining stable operation for over 1100 h at a current density of −0.5 A cm−2 in humid air at 600 °C. This research highlights the potential of surface modification on LSCF as a promising air electrode for PCCs to achieve efficient and stable operations.