15 March 2013 in Journal of the Physical Society of Japan
1 January 2013 in Europhysics Letters
22 December 2015 in RSC Advances
The suppression of the Jahn–Teller distortion elevates the oxygen evolution reaction activity for Mn3−xCoxO4 (0 ≤ x < 1).
11 July 2013 in Superconductor Science and Technology
The phase diagram of SmFeAsO1−xFx in terms of x is exhibited in this study. Specimens of SmFeAsO1−xFx from x = 0 to x = 0.3 were prepared by low-temperature sintering with slow cooling. The low-temperature sintering suppresses the formation of the amorphous FeAs, which is inevitably produced as an impurity when using high-temperature sintering. Moreover, slow cooling is effective in obtaining a high fluorine concentration. The compositional change from feedstock composition is quite small after this synthesis. We can reproducibly observe a record superconducting transition for an iron-based superconductor at 58.1 K. This achievement of a high superconducting transition is due to the success in substituting a large amount of fluorine. A shrinking of the a lattice parameter caused by fluorine substitution is observed and the substitutional rate of fluorine changes at x = 0.16.
15 February 2015 in Journal of the Physical Society of Japan
We show the observation of the coexistence of bulk superconductivity and ferromagnetism in CeO1-xFxBiS2(x = 0 - 1.0) prepared by annealing under high-pressure. In CeO1-xFxBiS2 system, both superconductivity and two types of ferromagnetism with respective magnetic transition temperatures of 4.5 K and 7.5 K are induced upon systematic F substitution. This fact suggests that carriers generated by the substitution of O by F are supplied to not only the BiS2 superconducting layers but also the CeO blocking layers. Furthermore, the highest superconducting transition temperature is observed when the ferromagnetism is also enhanced, which implies that superconductivity and ferromagnetism are linked to each other in the CeO1-xFxBiS2 system.Comment: 25 pages, 6 figure
1 July 2016 in Review of Scientific Instruments
A novel diamond anvil cell suitable for electrical transport measurements under high pressure has been developed. A boron-doped metallic diamond film was deposited as an electrode on a nano-polycrystalline diamond anvil using a microwave plasma-assisted chemical vapor deposition technique combined with electron beam lithography. The maximum pressure that can be achieved by this assembly is above 30 GPa. We report electrical transport measurements of Pb up to 8 GPa. The boron-doped metallic diamond electrodes showed no signs of degradation after repeated compression.