Instituto Politécnico Nacional, ESIME Unidad Zacatenco, Sección de Estudios de Posgrado e Investigación, Unidad Profesional Adolfo López Mateos, Ciudad de México, México
Auto-generated profile, based on publicly available information
Noe Gonzalez
Instituto Politécnico Nacional, ESIME Unidad Zacatenco, Sección de Estudios de Posgrado e Investigación, Unidad Profesional Adolfo López Mateos, Ciudad de México, México
In this paper, a constant speed control of slider-crank mechanisms for machine tools is proposed. A joint-task space hybrid controller based on a second-order sliding mode control and time-base generator was used to guarantee a constant speed trajectory tracking and a complete turn of the mechanism crank. A switching criterion was implemented in order to avoid the singularities located at the two extreme positions of the slider stroke. A trapezoidal speed profile with parabolic blends was designed directly over task space slider trajectory considering a constant cutting speed, the workpiece dimensions and the slider stroke length. Stability of the second-order sliding mode control was validated with the Lyapunov stability theory. Simulations were carried out to verify this approach.
In this work, a position control in task space for slider-crank mechanisms is presented. In order to apply linear controllers it is required to linearize the mechanism dynamics at an equilibrium point. However, complete dynamic knowledge is needed and the linearization technique gives an oversimplified model that affects the control performance. In this work, it is proposed a novel method to design task space controllers without using the complete knowledge of the mechanism dynamics and linearization methods. From the extended dynamic model of parallel robots, it can be seen that the end-effector (slider) dynamics is expressed as a linear system that can be used directly for the control design instead of the complete mechanism linear dynamics. The approach requires a minimal knowledge of the mechanism dynamics and avoids linearization methods. To verify our approach, it is used pole placement and sliding mode controllers whose gains are tuned according to the slider dynamics. A linear sensor is mounted at the slider to measure its position and avoids considering noise and disturbances at links before the slider. Simulations and experiments are presented to validate our approach using two kinds of slider-crank mechanisms.