This paper presents a discrete-time variable-structure-based control and a speed estimator designed for a permanent-magnet synchronous motor (PMSM). A cascade control scheme is proposed which provides accurate speed tracking performance. In this control scheme the speed estimator is a robust digital differentiator that provides the first derivative of the encoder position measurement. The analysis of the control stability is given and the ultimate boundedness of the speed tracking error is proved. The control scheme is experimentally tested on a commercial PMSM drive. Reported experimental evidence shows that the proposed solution produces good speed trajectory tracking performance and it is robust in the presence of disturbances affecting the system.
7 August 2002 in IEEE Transactions on Control Systems Technology
Actuator nonlinearities are often neglected in control system design, though they can remarkably affect systems performance. This paper presents sliding mode controllers able to robustly stabilize an intrinsically nonlinear uncertain plant, in the presence of dead zone or backlash in the actuator devices. These nonlinearities have been assumed uncertain, too, with known bounds on the parameters. In the case of backlash, two different approaches have been presented, obtained using a "quasistatic" and a "dynamic" description of the nonlinearity. Simulation results for a single input-single output (SISO) plant have been provided, addressing both the stabilization and the servo problem for a mechanical system representing a robot-like system with one link.
26 December 2006 in IEEE Transactions on Control Systems Technology
The actuator failure compensation problem is addressed in this brief. It is considered an uncertain linear plant, which is supposed to undergo unknown failures causing the plant input components to be stuck at some uncertain but bounded time functions. A sliding-mode-based control policy is presented, guaranteeing the detection of the fault and the identification of the failed component by means of a suitable test input. Once the failed component has been identified, the control law is reconfigured, redistributing the control activity among the controllers still working. The proposed controller has been tested by simulation on a benchmark problem