Aqueous Zn-ion batteries (AZIBs) present tremendous promise for large-scale energy storage owing to their intrinsically high safety, low cost and environmental friendliness. However, a huge challenge is the freezing of aqueous electrolytes at low temperatures. Herein, we report the introduction of formamide (FA), a low-cost, safe co-solvent with a high dielectric constant, as both a hydrogen bonding acceptor and donor, with an inexpensive zinc salt (zinc acetate), and the hybrid electrolyte exhibits a low freezing point lower than −40 °C and high ionic conductivity in a frozen environment. Experiments together with theoretical calculations demonstrate that FA can effectively anchor water molecules in a double-site hydrogen bonding interaction configuration and interrupt the original hydrogen bonding network, as well as confine free water activity, which significantly decreases the freezing point of the electrolyte and reduces the occurrence of hydrogen evolution reactions. In addition, the stronger coordination interaction between FA and Zn2+ can regulate the solvation structure of Zn2+, replace the water in the Zn2+ solvation sheath, realize uniform Zn deposition, avoid the formation of dendrites and inhibit the corrosion on the Zn surface. Consequently, an ultralong cycling life of 9500 h at 0.5 mA cm−2 in the Zn||Zn symmetric cell at −30 °C, a record cycling stability and cumulative capacity among the reported electrolytes for low-temperature AZIBs, and a high Coulombic efficiency of 99.91% in the Zn||Cu asymmetric cell are achieved. Zn||PANI batteries with the designed electrolyte possess ultra-high stable reversible capacity (107 mA h g−1 at 1 A g−1 for 22 000 cycles and 121 mA h g−1 at 5 A g−1 for 5500 cycles) and excellent rate capability (124.8 mA h g−1 at 10 A g−1) at –30 °C. Even at −40 °C, Zn||PANI cells can cycle 6000 times with a capacity of 80 mA h g−1 at 5 A g−1. This work provides a facile and feasible strategy to design inexpensive, stable and high-performance aqueous zinc ion batteries for applications at low temperatures.
20 March 2020 in IEEE Transactions on Terahertz Science and Technology
The investigation of single-pixel terahertz (THz) imaging opens up a new research direction for the development of THz imaging technology. In this work, we exploit a reflective single-pixel THz imaging system based on photoinduced dynamic masks. By combining the compressed sensing (CS) and inverse Fresnel diffraction (IFD) algorithms, a reflective THz spectral image is accurately reconstructed and the morphology of a sample is clearly observed. Three application potentials of the THz imaging system are fully proved, including time-of-flight measurement of a sample with multiple interfaces, noninvasive testing of a hidden object, and spectral identification of different chemical substances. The reflection-type measurement mode effectively improves the practicability of single-pixel THz imaging.
Terahertz (THz) near-field microscopy retains the advantages of THz radiation and realizes sub-wavelength imaging, which enables applications in fundamental research and industrial fields. In most THz near-field microscopies, the sample surface must be approached by a THz detector or source, which restricts the sample choice. Here, a technique was developed based on an air-plasma dynamic aperture, where two mutually perpendicular air-plasmas overlapped to form a cross-filament above a sample surface that modulated an incident THz beam. THz imaging with quasi sub-wavelength resolution (approximately λ/2, where λ is the wavelength of the THz beam) was thus observed without approaching the sample with any devices. Damage to the sample by the air-plasmas was avoided. Near-field imaging of four different materials was achieved, including metallic, semiconductor, plastic, and greasy samples. The resolution characteristics of the near-field system were investigated with experiment and theory. The advantages of the technique are expected to accelerate the advancement of THz microscopy.
14 February 2017 in Journal of Physics D: Applied Physics
We present a self-consistent model calculation to study the influence of a radio-frequency surface acoustic wave (SAW) on the dynamic processes of photo-generated free carriers, excitons and trions in a 2D MoS 2 flake with an odd number of layers. We found that the concentrations of excitons and trions decreased, while the lifetime of the free carriers increased when an external SAW field was applied. We attribute this phenomenon to the spatial separation of the electrons and holes, which are confined by a SAW-induced periodic type-II band-edge. We further studied the effect of the modulations on the spatiotemporal distributions of free carriers and excited quasiparticles by varying the amplitude and wavelength of the SAW field. We finally calculated the photoluminescent properties of the MoS 2 flake under modulation of the SAW field and compared our results with those of recent experiments.
20 February 2013 in Journal of Composite Materials
The reduced graphene/poly(vinylidene fluoride) nanocomposite films were prepared by the solution casting-thermal reduction process using graphene oxide and poly(vinylidene fluoride) resin. The results show that with the presence of reduced graphene nano sheets in the nanocomposite, the structure of poly(vinylidene fluoride) tends to transform from α- to β-phase and the β-phase fraction and its crystallinity are largely affected by the reduced graphene content. The thermal conductivity of poly(vinylidene fluoride) can be effectively improved by the reduced graphene nano sheets introduction and when the reduced graphene content increased to about 10.0 wt%, it is about two times higher than the pure poly(vinylidene fluoride), due to the excellent thermal conductivity of reduced graphene and formation of thermal conductive networks. With comparison of the pure poly(vinylidene fluoride), the reduced graphene/poly(vinylidene fluoride) nanocomposite films show a better tribological property at a low reduced graphene content (below 4.0 wt%), mainly owing to the lubricant and heat spreading effects of reduced graphene nano sheets. The friction coefficient and wear rate for 0.75 wt% reduced graphene/poly(vinylidene fluoride) nanocomposite film compared to the pure poly(vinylidene fluoride) are improved by 41.2% and 49.4%, respectively.
The instability of Zn anode resulting from corrosion and dendritic growth remain impeding the development of aqueous zinc‐ion batteries (AZIBs). In addition, the desolvation on the Zn surface is sluggish, which hinders the reaction kinetics and fast charge/discharge behavior of AZIBs. Herein, the uniform Zn deposition and fast desolvation are realized by using a hydrophilic fumed nano‐silica coating with zinc alginate (Alg) as a functional binder (Alg/SiO 2 @Zn). Combined theoretical calculation and experimental investigations show the interaction between the H 2 O in the solvation structure and ‐OH functional group of SiO 2 facilitates the desolvation process. In addition to the Zn 2+ guiding effect of Alg, the fast Zn 2+ diffusion along SiO 2 endows the homogeneous Zn deposition. Consequently, Alg/SiO 2 @Zn symmetric cell demonstrates exceptional plating/stripping reversibility and excellent long‐term cycle life at both 1 and 10 mAh cm −2 . A full cell assembled with Alg/SiO 2 @Zn and NaV 3 O 8 · x H 2 O cathode achieves a high capacity of 129 mAh g −1 at 4 A g −1 over 2650 cycles. Even under −20 °C, the battery maintains a high capacity of 136.5 mAh g −1 at 1 A g −1 after 1000 stable cycles. This study provides a facile strategy to achieve a highly stable Zn anode and gains deep insight into desolvation modulation via surface modification.