The solar wind has been implicated as a source of water on airless bodies such as the Moon, asteroids, and possibly Mercury, yet a kinetic and mechanistic chemical model consistent with present‐day observational data is still lacking. Utilizing available data sets on temperature‐driven water formation and desorption from metal oxides (e.g., SiO2, TiO2, and Al2O3) with surface hydroxyl defects (─OH) and experimental data from a lunar mare regolith Apollo sample (10084), the 2.8‐μm optical signal on the Moon is modeled. Specifically, the presence and persistence of this band result from the balance of formation and loss mechanisms associated with solar wind production and thermal transformation of hydroxyls on and within the regolith. This cycle involves formation and release of molecular water via recombinative desorption of the chemically bound ─OH. Though this mechanism forms gas‐phase H2O on the sunlit side, photodissociation and dissociative adsorption lead to rehydroxylation and very limited exospheric water over a lunation.
Water ice, abundant in the outer solar system, is volatile in the inner solar system. On the largest airless bodies of the inner solar system (Mercury, the Moon, Ceres), water can be an exospheric species but also occurs in its condensed form. Mercury hosts water ice deposits in permanently shadowed regions near its poles that act as cold traps. Water ice is also present on the Moon, where these polar deposits are of great interest in the context of future lunar exploration. The lunar surface releases either OH or H2O during meteoroid showers, and both of these species are generated by reaction of implanted solar wind protons with metal oxides in the regolith. A consequence of the ongoing interaction between the solar wind and the surface is a surficial hydroxyl population that has been observed on the Moon. Dwarf planet Ceres has enough gravity to have a gravitationally-bound water exosphere, and also has permanently shadowed regions near its poles, with bright ice deposits found in the most long-lived of its cold traps. Tantalizing evidence for cold trapped water ice and exospheres of molecular water has emerged, but even basic questions remain open. The relative and absolute magnitudes of sources of water on Mercury and the Moon remain largely unknown. Exospheres can transport water to cold traps, but the efficiency of this process remains uncertain. Here, the status of observations, theory, and laboratory measurements is reviewed.
18 June 2020 in Journal of Geophysical Research: Planets
Desorption activation energies of chemisorbed water on Apollo lunar Samples 14163 and 10084 were determined by temperature program desorption (TPD) experiments conducted under ultrahigh vacuum conditions. Desorption at the grain/vacuum interface and desorption/transport of water though the porous medium with readsorption were found to reproduce the experimental TPD signal. Signal from the grain/vacuum interface yielded desorption activation energies and site probability distributions. Highland sample 14163 exhibited a broad distribution of binding site energies peaking at 60 kJ mol−1, while mare sample 10084 exhibited a narrower distribution of binding site energies peaking at 65 kJ mol−1. The highland sample adsorbed approximately 30% more water than the more space weathered and mature mare sample, suggesting maturity may not be a good predictor of the degree of molecular water uptake on lunar regolith. Water desorption from the lunar surface over a typical lunar day was simulated with the measured coverage‐dependent activation energies of the mare and highland samples. The resulting desorption profile of water through a lunar temperature cycle is in general agreement with Lunar Reconnaissance Orbiter (LRO) Lyman‐α Mapping Project (LAMP) spacecraft‐based observations of trends for both highland and mare assuming ~1% submonolayer coverage and that photon stimulated desorption is neglected.
Radar observations of Mercury and the MErcury Surface, Space ENvironment, GEochemistry, and Ranging (MESSENGER) spacecraft data indicate the probable existence of water ice in the permanently shadowed polar regions. Generally, water is accepted to be of exogenous origin through delivery via comets and meteoritic impact. However, a continuous water formation process that involves thermal transformation of chemically stable mineral-bound hydroxyl groups produced by implanted solar-wind protons is readily available on the surface of Mercury. At typical temperatures prevailing on Mercury’s dayside surface, H2O can be produced from reactions involving OH groups on or within the H-saturated regolith grain interfaces. Similar reactions will also occur due to micrometeorite impact events on both the dayside and nightside. Once produced, H2O is released into the exosphere and then transported and processed via Jeans escape, photodissociation, dissociative adsorption, or condensation. Water reaching cold traps will be bound over geological periods. This simple water cycle will produce a highly chemically reduced surface and can deliver significant amounts of H2O to the permanently shadowed regions of Mercury over geological time periods. The overall process is an important but hitherto unnoticed source term that will contribute to the accumulation of water in the cold traps and polar regions of Mercury.