12 May 2021 in IEEE Transactions on Circuits and Systems II: Express Briefs
A novel single-feed filtering dielectric resonator antenna (FDRA) with quasi-elliptic bandpass response is proposed in this brief. The proposed FDRA consists of a shunted slotline stepped-impedance resonator (SSIR), a rectangular dielectric resonator antenna (DRA) and a microstrip feedline with a pair of transverse arms. The antenna is excited in the fundamental TE $_{11\delta }$ mode, the transverse arm mode and the two SSIR modes. Moreover, three radiation nulls are produced near the edges of the passband by the SSIR and the transverse arm of microstip feedline, respectively. A prototype FDRA is fabricated and measured, which offers a bandwidth ( $| S_{11} | < -10$ dB) of 21.14% (3.13 - 3.87 GHz), and a peak realized gain of 5.3 dBi within passband. The realized gain shows a decline of 20 dB at passband-edge, which exhibits high selectivity.
18 March 2021 in Radio Science
Millimeter wave (mmWave)‐based massive multiple‐input multiple‐output (MIMO) beamforming technology is one of the key technologies in the fifth‐generation (5G) network. In this paper, we apply mmWave to high‐speed railway (HSR) communication scenario to meet its increasingly growing demands for tremendous data rate and reliable mobile services. The HSR mmWave communication system uses a control/user (C/U) plane separation structure; that is, control information and user information are transmitted through the high‐frequency micro base station (BS) and the low‐frequency macro BS, respectively. Then, an optimized beam width and power allocation scheme is proposed, which is combined with the mobile relay (MR) technology to utilize the architecture of the large‐scale antenna beamforming. In the proposed scheme, we introduce a power factor related to the change of train speed. According to the power factor, the service beam width is adjusted dynamically and the transmit power of the beams from two simultaneously served mmWave access points (APs) is jointly calculated. Simulation results show that, compared with the traditional uniform beam width scheme, the proposed adaptive beam width and power allocation scheme can maximize the total service volume within the maximum transmit power range.
30 August 2021 in International Journal of RF and Microwave Computer-Aided Engineering
7 November 2018 in International Journal of RF and Microwave Computer-Aided Engineering
6 March 2024 in AEU - International Journal of Electronics and Communications
3 September 2023 in AEU - International Journal of Electronics and Communications