1 April 2021 in Progress in Aerospace Sciences
1 November 2020 in Aerospace Science and Technology
5 February 2019 in Multibody System Dynamics
1 March 2019 in International Journal of Space Structures
This article studies tensegrity structures known as “D-bar” systems for applications as lightweight components for mechanical energy absorption. Aerospace structures such as planetary landers, designed to absorb energy from large impact loads while requiring minimal mass, would benefit from such components. Previous studies showed that D-bar systems support compressive loads with minimal mass compared with continuum options such as single columns. In this work, analytical equations for the mechanical (elastic) energy stored in D-bar systems of any complexity (a quantity proportional to the number of strings/bars in the system) are derived for the first time. The energy stored in D-bar systems is compared with that of bent buckled beams used in “flexible-bar tensegrity” concepts, which were proposed in the literature as energy absorption components for planetary landers. Comparisons are made between D-bar systems and bent buckled beams as isolated components subjected to a compressive load and as components of planetary landers. In all comparisons, the results show that D-bar systems of low complexity allow for higher energy storage and lower mass than bent buckled beams. Thus, it is concluded that D-bar systems can enhance the design of planetary landers and other applications that need lightweight mechanical energy absorption components.
24 October 2019 in Journal of Open Source Software
10 March 2020 in IEEE Robotics and Automation Letters
This paper proposes two approaches to control the shape of the structure or the position of the end effector for a soft-robotic application. The first approach is a model based approach where the non-linear dynamics of the tensegrity system is used to regulate position, velocity and acceleration to the specified reference trajectory. The formulation uses state feedback to obtain the solution for the control (tension in the strings) as a linear programming problem. The other model-free approach is a novel decoupled data based control (D2C) which first optimizes a deterministic open-loop trajectory using a blackbox (no actual model) simulation model and then develops a linear quadratic regulator around the linearized open-loop trajectory. A 2-dimensional tensegrity robotic reacher is used to compare the results for both the approaches for a given cost function. The D2C approach is also used to study two more complex tensegrity examples whose dynamics is difficult to model analytically.