29 August 2023 in Nature Communications
Operando monitoring of complex physical and chemical activities inside rechargeable lithium-ion batteries during thermal runaway is critical to understanding thermal runaway mechanisms and giving early warning of safety-related failure. However, most existing sensors cannot survive during such extremely hazardous thermal runaway processes (temperature up to 500 °C accompanied by fire and explosion). To address this, we develop a compact and multifunctional optical fiber sensor (12 mm in length and 125 µm in diameter) capable of insertion into commercial 18650 cells to continuously monitor internal temperature and pressure effects during cell thermal runaway. We observe a stable and reproducible correlation between the cell thermal runaway and the optical response. The sensor’s signal shows two internal pressure peaks corresponding to safety venting and initiation of thermal runaway. Further analysis reveals that a scalable solution for predicting imminent thermal runaway is the detection of the abrupt turning range of the differential curves of cell temperature and pressure, which corresponds to an internal transformation between the cell reversible and irreversible reactions. By raising an alert even before safety venting, this new operando measurement tool can provide crucial capabilities in cell safety assessment and warning of thermal runaway.
31 January 2024 in Energy Conversion and Management
31 October 2023 in Journal of Energy Storage
13 January 2024 in Energy Storage Materials
15 July 2025 in Process Safety and Environmental Protection
17 April 2026 in Carbon Energy
The occurrence of unexpected Li plating and dendrite growth on graphite anodes poses significant challenges to the practical application of lithium‐ion batteries. While existing studies have highlighted the superiority of elevated temperatures in alleviating Li plating and Li dendrite growth. We enable a comprehensive electrochemical‐thermal investigation of the Li plating mechanism at an elevated temperature of 60°C, induced by slight over‐lithiation on Li|graphite coin cells. By combining voltage evolution with in‐situ heat generation, we identify a distinctive exothermic peak corresponding to the Li plating plateau. Intriguingly, we discover a characteristic exothermic peak during the relaxation stage, attributed to the simultaneous occurrence of Li stripping and re‐intercalation, which is beyond our regular cognition and serves as a novel indicator of Li plating. The heat contributions analysis further indicates the weakened Li intercalation heat generation once Li plating occurs. Finally, from the post‐mortem characterizations, the surface morphologies, chemical composition, and Li content quantification of the lithiated graphite without Li plating and at different Li plating cycles are obtained to reveal the Li nucleation‐growth mechanism. The results demonstrate that a total of 0.540 mg metallic Li is plated on a coin cell over the whole cycle. This work provides a new insight into the electrochemical‐thermal coupling mechanism of Li plating at elevated temperature.