8 January 2021 in IEEE Open Journal of the Communications Society
Reconfigurable Intelligent Surface (RIS) has emerged as a promising technology in wireless networks to achieve high spectrum and energy efficiency. RIS typically comprises a large number of low-cost nearly passive elements that can smartly interact with the impinging electromagnetic waves for performance enhancement. However, optimally configuring massive number of RIS elements remains a challenge. In this article, we present a machine learning (ML) based modeling approach that learns the interactions between the phase shifts of the RIS elements and receiver (Rx) location attributes and uses them to predict the achievable rate directly without using channel state information (CSI) or received pilots. Once learned, our model can be used to predict optimal RIS configuration for any new receiver locations in the same wireless network. We leverage deep learning (DL) techniques to build our model and study its performance and robustness. Simulation results demonstrate that the proposed DL model can recommend near-optimal RIS configurations for test receiver locations which achieved close to an upper bound performance that assumes perfect channel knowledge. Our DL model was trained using less than 2% of the total receiver locations. This promising result represents great potential in developing a practical solution for the optimal phase shifts of RIS elements without requesting CSI from the wireless network infrastructure.
16 March 2020 in IEEE Transactions on Aerospace and Electronic Systems
This paper explores the effects of three-dimensional (3D) antenna radiation pattern and backhaul constraint on optimal 3D path planning problem of an unmanned aerial vehicle (UAV), in interference prevalent downlink cellular networks. We consider a cellular-connected UAV that is tasked to travel between two locations within a fixed time and it can be used to improve the cellular connectivity of ground users by acting as a relay. Since the antenna gain of a cellular base station changes significantly with the UAV altitude, the UAV can improve the signal quality in its backhaul link by changing its height over the course of its mission. This problem is non-convex and thus, we explore the dynamic programming technique to solve it. We show that the 3D optimal paths can introduce significant network performance gain over the trajectories with fixed UAV heights.
19 January 2023 in IEEE Transactions on Aerospace and Electronic Systems
Reliable wireless coverage in drone corridors is critical to enable a connected, safe, and secure airspace. To support beyond visual line of sight (BVLOS) operations of aerial vehicles in a drone corridor, cellular base stations (BSs) can serve as a convenient infrastructure as they are widely deployed to provide seamless wireless coverage. However, antennas in the existing cellular networks are down-tilted to optimally serve their ground users, which results in coverage holes at higher altitudes when they are used to serve drones. In this paper, we consider the use of additional uptilted antennas at each cellular BS and optimize the uptilt angle to maximize the wireless coverage probability across a given drone corridor. Through numerical results, we characterize the optimal value of the antenna uptilt angle for a given antenna pattern as well as the minimum/maximum altitudes of the drone corridor.
2 August 2024 in IEEE Aerospace and Electronic Systems Magazine
By serving as an analog to traffic signal lights, communication signaling for drone to drone communications holds the key to the success of advanced air mobility (AAM) in both urban and rural settings. Deployment of AAM applications such as air taxis and air ambulances, especially at large-scale, requires a reliable channel for a point-to-point and broadcast communication between two or more aircraft. Achieving such high reliability, in a highly mobile environment, requires communication systems designed for agility and efficiency. This paper presents the foundations for establishing and maintaining a reliable communication channel among multiple aircraft in unique AAM settings. Subsequently, it presents concepts and results on wireless coverage and mobility for AAM services using cellular networks as a ground network infrastructure. Finally, we analyze the wireless localization performance at 3D AAM corridors when cellular networks are utilized, considering different corridor heights and base station densities. We highlight future research directions and open problems to improve wireless coverage and localization throughout the manuscript
17 July 2023 in IEEE Open Journal of Vehicular Technology
Estimating the speed of aerial user equipment (UE) is critically important to provide reliable mobility management for cellular-connected unmanned aerial vehicles (UAVs) since this can enhance the quality of service. The 3GPP standard uses the number of handovers made by a UE during a predefined time period to estimate the speed and the mobility state efficiently. In this paper, we introduce an approximation to the probability mass function of handover count (HOC) as a function of a cellular-connected UAV's height and velocity, HOC measurement time window, and different ground base station (GBS) densities. Afterward, we derive the Cramer-Rao lower bound (CRLB) for the speed estimate of a UAV and also provide a simple biased estimator for its speed based on the GBS density and HOC measurement period. We show that for a low handover parameter, the biased estimator turns into a minimum variance unbiased estimator (MVUE). Using this estimator, we study the problem of detecting the mobility state of a UAV as low, medium, or high mobility as per the 3GPP specifications. Using our proposed MVUE, we also characterize the accuracy improvement in speed estimation and mobility state detection as the GBS density and the HOC measurement window increase.