14 April 2015 in SAE International Journal of Advances and Current Practices in Mobility
A new constant volume combustion chamber (CVCC) apparatus is presented that calculates the cetane number (CN) of fuels from their ignition delay by means of a primary reference fuel calibration. It offers the benefits of low fuel consumption, suitability for non-lubricating substances, accurate and fast measurements and a calibration by primary reference fuels (PRF). The injection system is derived from a modern common-rail passenger car engine.The apparatus is capable of fuel injection pressures up to 1200 bar and requires only 40 ml of the test fuel. The constant volume combustion chamber can be heated up to 1000 K and pressurized up to 50 bar. Sample selection is fully automated for independent operation and low levels of operator involvement. Capillary tubes employed in the sampling system can be heated to allow the measurement of highly viscous fuels.For primary reference fuel calibration, ignition delay times of six mixtures with defined CN in the range of 35 to 70 are measured and correlated to their CN using a mathematical best fit curve. First tests showed good correlation with conventionally determined engine CN for several diesel fuels.Methanol and ethanol with a CN below 20 were measured using a special low-CN calibration and higher chamber temperature and pressure. Two oxygenates with a high CN above 100 were measured after mixing with a low-CN primary reference fuel. This blending CN method allows extrapolating the CN for samples above the calibrated measurement range.
15 February 2022 in Environmental Science: Atmospheres
Polyoxymethylene dimethyl ethers (OME) are promising substitutes for fossil diesel fuel. Besides the possibility of closing the carbon cycle, OME also feature soot-free combustion. Although this has been demonstrated sufficiently, nanoparticle emission in OME exhaust is mainly unknown. Many studies provide information about the particle size distribution (PSD) in the exhaust of OME-fueled diesel engines, but lack a distinction between solid particles and particles of a volatile nature. This distinction is necessary in order to evaluate the potential of OME regarding Euro VI and the Euro VII exhaust gas legislation being discussed. This study investigates the PSD of fossil diesel and the OME exhaust of a heavy-duty engine with and without removal of the volatile fraction via a catalytic stripper, by means of a purpose-built sampling system based on proposals from the Particle Measurement Programme (PMP). The experiments showed that most of the nuclei mode investigated in OME operation is of a volatile nature and that the solid particle number (PN) emission is below that of Euro VI diesel operation. Moreover, the results indicate that a state-of-the-art aftertreatment system removes most of the particle emission, regardless of whether it is volatile or solid. Selective catalytic reduction using aqueous urea dosing increases solid particle emission, especially in the sub-23 nm range. However, a PMP-conformant measurement of PN23 and PN10 during WHSC and WHTC runs demonstrated that the PN emission of an OME-fueled engine falls below the average immission level of urban and regional background in Germany.
30 June 2022 in Environmental Science: Advances
Cold-start emissions of the sustainable alternative diesel fuel OME are predominantly NO
x
, formaldehyde, formic acid and unburned OME. Electrical heating in combination with fuel dosing is an effective method for after-treatment system heating.