1 February 2020 in Review of Scientific Instruments
The requirements of ITER neutral beam injectors (1 MeV, 40 A negative deuterium ion current for 1 h) have never been simultaneously attained; therefore, a dedicated Neutral Beam Test Facility (NBTF) was set up at Consorzio RFX (Padova, Italy). The NBTF includes two experiments: SPIDER (Source for the Production of Ions of Deuterium Extracted from Rf plasma), the full-scale prototype of the source of ITER injectors, with a 100 keV accelerator, to investigate and optimize the properties of the ion source; and MITICA, the full-scale prototype of the entire injector, devoted to the issues related to the accelerator, including voltage holding at low gas pressure. The present paper gives an account of the status of the procurements, of the timeline, and of the voltage holding tests and experiments for MITICA. As for SPIDER, the first year of operation is described, regarding the solution of some issues connected with the radiofrequency power, the source operation, and the characterization of the first negative ion beam.
1 September 2019 in Fusion Engineering and Design
27 April 2023 in Journal of Vacuum Science & Technology B
An improvement for the vacuum system of the multidriver radio frequency (RF) prototype negative ion source SPIDER has been developed, to allow operating at high RF power, while minimizing the breakdown probability on the outside of the plasma source. A first-of-its-kind large nonevaporable getter (NEG) pump, based on a modular design of 384 cartridges totaling about 350 kg of ZAO® alloy (composed by Zr-Ti-V-Al) with an installed pumping speed at a room temperature of 330 m3/s for hydrogen, will complement the existing pumping system, based on eight cryogenic pumps and four turbomolecular pumps totaling about 90 m3/s in hydrogen. The vessel pressure during absorption is expected to be between 20 and 40 mPa, while during the getter regeneration, the peak operating pressure will be around 2 Pa. The NEG pump will use an additional vessel module, with integrated thermal shields to protect the in-vessel components during activation and regeneration of the pump, to be carried out at temperatures in the range of 550–600 °C. Integrated thermal analyses were carried out to verify the low heat load on pre-existing in-vessel components with a low limit of acceptable temperature, and to provide boundary conditions for the mechanical verifications of the pump structure. The scenario of cyclic hydrogen load was calculated considering the SPIDER operation modes, the expected gas throughput, and the cumulated load to the pump, to determine the regeneration temperature and auxiliary pumping necessary to make the regeneration duration compatible with the high availability of the system. The upgrade of the auxiliary pumping system is also described, as well as the mitigation of air or water exposure risk during regeneration of the NEG pump.
1 September 2019 in Fusion Engineering and Design
1 February 2020 in Review of Scientific Instruments
Vacuum systems of neutral beam injectors have very demanding requirements in terms of pumping speed, throughput, and capacity. Due to their high affinity to hydrogenic species, porous sintered Non-Evaporable Getters (NEG) are a possible candidate for deployment in giant hydrogen ion sources and neutral beam injectors for fusion. This paper presents the numerical interpretation of experimental tests on a recently developed NEG cartridge, that is part of a modular pump under development for neutral beam injectors. The cartridge is composed of six stacks of ZAO® porous sintered NEG disks and a heater. It was tested under hydrogen loads relevant for neutral beam injectors, namely, at constant pressure or constant flow, such that the hydrogen pressure was in the range of 20 mPa–40 mPa. The result of the sorption test was reproduced by a three dimensional flow simulation in molecular regime to determine the actual pumping speed, the effective sticking coefficient, and the uniformity of the gas load on the various NEG disks. The procedure developed and the results obtained provide the basic understanding for interpreting the large-scale tests on the modular pump, consisting of 34 of these cartridges.
1 February 2020 in Fusion Engineering and Design