Celia Z. Rosecrans

Celia Z. Rosecrans

Auto-generated profile, based on publicly available information

Celia Z. Rosecrans

U.S Geological Survey, Sacramento, CA, USA

Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2022 in Science of The Total Environment
Verified
Journal Article
Closed access
CRCelia Z. Rosecrans
Celia Z. Rosecrans
KBKenneth Belitz
Kenneth Belitz
KRKatherine M. Ransom
Katherine M. Ransom
PSPaul E. Stackelberg
Paul E. Stackelberg
PMPeter B. McMahon
Peter B. McMahon

26 January 2021 in Science of The Total Environment
Verified
Journal Article
Open access
CRCelia Z. Rosecrans
Celia Z. Rosecrans
MLMathew K. Landon
Mathew K. Landon
PMPeter B. McMahon
Peter B. McMahon
JGJanice M. Gillespie
Janice M. Gillespie
JKJustin T. Kulongoski
Justin T. Kulongoski
TDTracy A. Davis
Tracy A. Davis
Groundwater samples collected from irrigation, monitoring, and municipal supply wells near the Oxnard Oil Field were analyzed for chemical and isotopic tracers to evaluate if thermogenic gas or water from hydrocarbon-bearing formations have mixed with surrounding groundwater. New and historical data show no evidence of water from hydrocarbon-bearing formations in groundwater overlying the field. However, thermogenic gas mixed with microbial methane was detected in 5 wells at concentrations ranging from 0.011–9.1 mg/L. The presence of these gases at concentrations <10 mg/L do not indicate degraded water quality posing a known health risk. Analysis of carbon isotopes (δ13C-CH4) and hydrogen isotopes (δ2H-CH4) of methane and ratios of methane to heavier hydrocarbon gases were used to differentiate sources of methane between a) microbial, b) thermogenic or c) mixed sources. Results indicate that microbial-sourced methane is widespread in the study area, and concentrations overlap with those from thermogenic sources. The highest concentrations of thermogenic gas were observed in proximity to relatively high density of oil wells, large injection volumes of water disposal and cyclic steam, shallow oil development, and hydrocarbon shows in sediments overlying the producing oil reservoirs. Depths of water wells containing thermogenic gas were within approximately 200 m of the top of the Vaca Tar Sand production zone (approximately 600 m below land surface). Due to the limited sampling density, the source and pathways of thermogenic gas detected in groundwater could not be conclusively determined. Thermogenic gas detected in the absence of co-occurring water from hydrocarbon-bearing formations may result from natural gas migration over geologic time from the Vaca Tar Sand or deeper formations, hydrocarbon shows in sediments overlying producing zones, and/or gas leaking from oil-field infrastructure. Denser sampling of groundwater, potential end-members, and pressure monitoring could help better distinguish pathways of thermogenic gases.

1 August 2021 in Applied Geochemistry
Verified
Journal Article
Open access
PMPeter B. McMahon
Peter B. McMahon
MLMathew K. Landon
Mathew K. Landon
TDTracy A. Davis
Tracy A. Davis
MWMichael T. Wright
Michael T. Wright
CRCelia Z. Rosecrans
Celia Z. Rosecrans
AHAndrew G. Hunt
Andrew G. Hunt

1 January 2008 in Scientific Investigations Report
Verified
Other
Closed access
CZCelia Zamora
Celia Zamora
The lower Merced River Basin was chosen by the U.S. Geological Survey?s (USGS) National Water Quality Assessment Program (NAWQA) to be included in a national study on how hydrological processes and agricultural practices interact to affect the transport and fate of agricultural chemicals. As part of this effort, surface-water?ground-water (sw?gw) interactions were studied in an instrumented 100-m reach on the lower Merced River. This study focused on estimating vertical rates of exchange across the sediment?water interface by direct measurement using seepage meters and by using temperature as a tracer coupled with numerical modeling. Temperature loggers and pressure transducers were placed in monitoring wells within the streambed and in the river to continuously monitor temperature and hydraulic head every 15 minutes from March 2004 to October 2005. One-dimensional modeling of heat and water flow was used to interpret the temperature and head observations and deduce the sw?gw fluxes using the USGS...

1 January 2020
Verified
Report
Closed access
PDF file
CRCelia Z. Rosecrans
Celia Z. Rosecrans
MMMaryLynn Musgrove
MaryLynn Musgrove
First posted September 8, 2020 Director, California Water Science Center U.S. Geological Survey 6000 J Street, Placer Hall Sacramento, California 95819 Groundwater provides nearly half of the Nation’s drinking water. As the Nation’s population grows, the importance of (and need for) high-quality drinking-water supplies increases. As part of a national-scale effort to assess groundwater quality in principal aquifers (PAs) that supply most of the groundwater used for public supply, the U.S. Geological Survey National Water-Quality Assessment (NAWQA) Project staff sampled six principal aquifers in the western United States between 2013 and 2017: (1) the Basin and Range carbonate-rock aquifers, (2) Basin and Range basin-fill aquifers, (3) Rio Grande aquifer system, (4) High Plains aquifer, (5) Colorado Plateaus aquifers, and (6) Columbia Plateau basaltic-rock aquifers. These six PAs supply a large part of the Nation’s drinking water and cover a large geographic extent of the western conterminous United States. Groundwater samples were analyzed for a large suite of water-quality constituents including major ions, nutrients, trace elements, volatile organic compounds (VOCs), pesticide compounds, radioactive constituents, age tracers, and, in selected PAs, perchlorate. Two types of assessments were made: (1) a status assessment that describes the quality of the groundwater resource at time of collection and (2) an understanding assessment that evaluates relations between groundwater quality and potential explanatory factors that represent characteristics of the aquifer system. The assessments characterize untreated groundwater quality, which might be different than the quality of drinking water delivered to consumers. The assessments are based on water-quality data collected from 352 wells and 6 springs using an equal-area grid sampling design. This sampling approach allows for the estimation of the proportion of high, moderate, or low concentrations relative to federal water-quality benchmarks of selected constituents in the area of each PA. Results were compared to established benchmarks for drinking-water quality to provide context for evaluating the quality of untreated groundwater: Federal regulatory benchmarks for protecting human health, non-regulatory human-health benchmarks, and non-regulatory benchmarks for nuisance chemicals. Not all constituents that were analyzed have benchmarks and thus were not considered for assessments. Concentrations are characterized as high if they are greater than their benchmark. Concentrations are considered moderate if they are greater than one-half their benchmark (for inorganic constituents), or greater than one-tenth their benchmark (for organic constituents). Concentrations are considered low if they are less than moderate or the constituent was not detected. Status assessment results indicated that inorganic constituents more commonly occurred at high and moderate concentrations in the six PAs than organic constituents, and organic constituents predominately occurred at low concentrations. Inorganic constituents that exceeded health-based benchmarks (high concentrations) were present in all six PAs; aquifer-scale proportion were 30 percent in the Rio Grande aquifer system, 22 percent in the Basin and Range basin-fill aquifers, 20 percent in the Basin and Range carbonate-rock aquifers, 19 percent in the High Plains aquifer, 16 percent in the Colorado Plateaus aquifers, and 8 percent in the Columbia Plateau basaltic-rock aquifers. Arsenic, fluoride, manganese, and total dissolved solids were the constituents most commonly present at high concentrations. Organic constituents with human-health benchmarks (pesticide compounds and VOCs) did not occur at high concentrations and moderate concentrations were infrequent; aquifer-scale proportions ranged from 0 to 5 percent. Detections of organic compounds at low concentrations, however, occurred in all six PAs, with detection frequencies ranging from 10 to 26 percent for pesticide compounds and from 10 to 46 percent for VOCs. Specific organic constituents with detection frequencies greater than 10 percent were four herbicides (atrazine, didealkylatrazine, bromoform, and propazine), one insecticide (propoxur), and two VOCs (the trihalomethanes chloroform and bromodichloromethane). Where collected—in the Rio Grande aquifer system and High Plains aquifer—perchlorate did not occur at high concentrations; moderate aquifer-scale proportions were 3 and 11 percent, respectively. The understanding assessment included statistical tests to evaluate relations between constituent concentrations and potential explanatory factors to identify natural and human factors that affect groundwater quality. Potential explanatory factors included depth to bottom of well perforation, groundwater age category, land use, aquifer lithology, hydrologic conditions, and geochemical conditions. Higher concentrations of trace elements, radioactive constituents, and constituents with non-health-based benchmarks generally were associated with unconsolidated sand and gravel aquifer lithologies, premodern groundwater age, greater aridity, and more alkaline pH. Organic constituents with detection frequencies greater than 10 percent generally were associated with urban land use, shallower well depths, and higher total dissolved solids concentrations. The results for the six western PAs provide important insights into the quality of groundwater that is used for drinking water in the western United States, as well as natural and human factors that affect groundwater quality in this region.

1 January 2017
Verified
Report
Closed access
PDF file
CRCelia Z. Rosecrans
Celia Z. Rosecrans
BNBernard T. Nolan
Bernard T. Nolan
JGJo Ann M. Gronberg
Jo Ann M. Gronberg
This scientific investigations map is a product of the U.S. Geological Survey (USGS) National Water-Quality Assessment (NAWQA) project modeling and mapping team. The prediction grids depicted in this map are of continuous pH and are intended to provide an understanding of groundwater-quality conditions at the domestic and public supply drinking water zones in the groundwater of the Central Valley of California. The chemical quality of groundwater and the fate of many contaminants is often influenced by pH in all aquifers. These grids are of interest to water-resource managers, water-quality researchers, and groundwater modelers concerned with the occurrence of natural and anthropogenic contaminants related to pH. In this work, the median well depth categorized as domestic supply was 30 meters below land surface, and the median well depth categorized as public supply is 100 meters below land surface. Prediction grids were created using prediction modeling methods, specifically boosted regression trees (BRT) with a Gaussian error distribution within a statistical learning framework within the computing framework of R (http://www.r-project.org/). The statistical learning framework seeks to maximize the predictive performance of machine learning methods through model tuning by cross validation. The response variable was measured pH from 1,337 wells and was compiled from two sources: USGS National Water Information System (NWIS) database (all data are publicly available from the USGS: http://waterdata.usgs.gov/ca/nwis/nwis) and the California State Water Resources Control Board Division of Drinking Water (SWRCB-DDW) database (water quality data are publicly available from the SWRCB: http://www.waterboards.ca.gov/gama/geotracker_gama.shtml). Only wells with measured pH and well depth data were selected, and for wells with multiple records, only the most recent sample in the period 1993–2014 was used. A total of 1,003 wells (training dataset) were used to train the BRT model, and 334 wells (hold-out dataset) were used to validate the prediction model. The training r-squared was 0.70, and the root-mean-square error (RMSE) in standard pH units was 0.26. The hold-out r-squared was 0.43, and RMSE in standard pH units was 0.37. Predictor variables consisting of more than 60 variables from 7 sources were assembled to develop a model that incorporates regional-scale soil properties, soil chemistry, land use, aquifer textures, and aquifer hydrology. Previously developed Central Valley model outputs of textures (Central Valley Textural Model, CVTM; Faunt and others, 2010) and MODFLOW-simulated vertical water fluxes and predicted depth to water table (Central Valley Hydrologic Model, CVHM; Faunt, 2009) were used to represent aquifer textures and groundwater hydraulics, respectively. In this work, wells were attributed to predictor variable values in ArcGIS using a 500-meter buffer.Faunt, C.C., ed., 2009, Groundwater availability in the Central Valley aquifer, California: U.S. Geological Survey Professional Paper 1776, 225 p., accessed at https://pubs.usgs.gov/pp/1766/.Faunt, C.C., Belitz, K., and Hanson, R.T., 2010, Development of a three-dimensional model of sedimentary texture in valley-fill deposits of Central Valley, California, USA: Hydrogeology Journal, v. 18, no. 3, p. 625–649, https://doi.org/10.1007/s10040-009-0539-7.