12 June 2008 in Nanotechnology
If graphene is ever going to live up to the promises of future nanoelectronic devices, an easy and cheap route for mass production is an essential requirement. A way to extend the capabilities of plasma-enhanced chemical vapour deposition to the synthesis of freestanding few-layer graphene is presented. Micrometre-wide flakes consisting of four to six atomic layers of stacked graphene sheets have been synthesized by controlled recombination of carbon radicals in a microwave plasma. A simple and highly reproducible technique is essential, since the resulting flakes can be synthesized without the need for a catalyst on the surface of any substrate that withstands elevated temperatures up to 700 °C. A thorough structural analysis of the flakes is performed with electron microscopy, x-ray diffraction, Raman spectroscopy and scanning tunnelling microscopy. The resulting graphene flakes are aligned vertically to the substrate surface and grow according to a three-step process, as revealed by the combined analysis of electron microscopy and x-ray photoelectron spectroscopy.
11 June 2010 in ChemSusChem
Access to cellulose: Carbon nanofibers grown over Ni supported on γ‐Al2O3 act as efficient catalysts for the one‐pot conversion of cellulose to sugar alcohols, owing to the enhanced accessibility of the water‐insoluble substrate towards the active catalytic sites. The new catalyst design concept yields unprecedented results for selective cellulose conversion using inexpensive Ni catalysts.
29 January 2009 in Advanced Materials
4 September 2012 in Physica Status Solidi (a)
20 May 2008 in Physical Review B
A data-acquisition and data-processing method is proposed that aims at minimizing the effect of retardation on the Kramers–Kronig analysis of valence electron energy-loss spectra. This method is applied to diamond, which, due to its high dielectric constant, is a material that shows strong retardation effects and thus is a challenging material to be studied by valence electron energy-loss spectroscopy. The results obtained show a significant improvement but still show small discrepancies with respect to optical data, which are most likely due to the residual retardation contributions and the fact that nonzero momentum transfers are measured.