X-ray computed tomography (XCT) is a validated and frequently used tool to verify part geometry and to perform a non-destructive inspection of additive manufacturing parts. However, the acquisition of a large number of x-ray projections generates long inspection times. This conflicts with a high throughput of the production process and hinders the integration of XCT as an in-line quality control procedure for low-end parts. In this paper, we propose a method to obtain three-dimensional (3D) information of the internal pores from a limited view or limited angle scan. The method combines a forward projection model of a cone-beam x-ray system and a deep learning neural network to directly classify each individual voxel, based on the x-ray projections in order to avoid the reconstruction and segmentation step. Accompanying reconstruction artifacts for limited view and limited angle XCT scans are thereby reduced, while preserving 3D information of the pores, defects or inclusions inside the material. The method is validated on real x-ray projections of polymer laser sintered industrial parts and shows a significant reduction in the required x-ray projections, hence acquisition time.
2 May 2024 in IEEE Transactions on Computational Imaging
This work is concerned with fan- and cone-beam computed tomography with circular source trajectory, where the reconstruction inverse problem requires an accurate knowledge of source, detector and rotational axis relative positions and orientations. We address this additional inverse problem as a preceding step of the reconstruction process directly from the acquired projections. In the cone-beam case, we present a method that estimates both the detector shift (orthogonal to both focal and rotational axes) and the in-plane detector rotation (over the focal axis) based on the variable projection optimization approach. In addition and for the fan-beam case, two new strategies with low computational cost are presented to estimate the detector shift based on a fan-beam symmetry condition. The methods are validated with simulated and experimental industrial tomographic data with code examples available for both fan- and cone-beam geometries.