The modulus of elasticity of a concrete depends on the elastic stiffness of both the cementitious matrix and the aggregate–ITZ system, which includes any slippage mechanisms under loading between the aggregate and the cementitious matrix within the interfacial transition zone (ITZ). A procedure is presented in this paper to estimate the elastic stiffness of an aggregate–ITZ system within a cementitious matrix, by considering the relative volumes and the porosities of the concrete components. The method was validated by determining the elastic stiffness of both the limestone–ITZ and the electric arc furnace slag (EAFS)–ITZ systems when embedded in a slag-based cementitious matrix. The greater stiffness of the EAFS–ITZ system in comparison with the natural aggregate system explained the higher strength and modulus of elasticity of the concrete following additions of EAFS. Moreover, having determined those parameters, the elastic moduli of concretes with a similar cementitious matrix could then be accurately estimated.
This study deals with the edge effects in angle-ply composite laminates subjected to tensile test. The submodeling technique is used to achieve the numerical results. In a first step, a [45/–45]s laminated strip is studied, comparing the results with the previous approaches. The fulfilment of equilibrium equations by the stresses obtained numerically is studied to delimit the zone with inaccurate results due to the singularity of the problem. Antisymmetric configurations are analyzed enclosing the validity of the numerical results near the edges to the limits previously obtained. The aspect ratio and the orientation angle have been varied to analyze their effect.