20 April 2015 in Applied Physics Letters
Terahertz-frequency quantum cascade lasers (THz QCLs) based on bound-to-continuum active regions are difficult to model owing to their large number of quantum states. We present a computationally efficient reduced rate equation (RE) model that reproduces the experimentally observed variation of THz power with respect to drive current and heat-sink temperature. We also present dynamic (time-domain) simulations under a range of drive currents and predict an increase in modulation bandwidth as the current approaches the peak of the light–current curve, as observed experimentally in mid-infrared QCLs. We account for temperature and bias dependence of the carrier lifetimes, gain, and injection efficiency, calculated from a full rate equation model. The temperature dependence of the simulated threshold current, emitted power, and cut-off current are thus all reproduced accurately with only one fitting parameter, the interface roughness, in the full REs. We propose that the model could therefore be used for rapid dynamical simulation of QCL designs.
11 December 2015 in Journal of Applied Physics
We investigate electron transport in epitaxially grown nitride-based resonant tunneling diodes (RTDs) and superlattice sequential tunneling devices. A density-matrix model is developed, and shown to reproduce the experimentally measured features of the current–voltage curves, with its dephasing terms calculated from semi-classical scattering rates. Lifetime broadening effects are shown to have a significant influence in the experimental data. Additionally, it is shown that the interface roughness geometry has a large effect on current magnitude, peak-to-valley ratios and misalignment features; in some cases eliminating negative differential resistance entirely in RTDs. Sequential tunneling device characteristics are dominated by a parasitic current that is most likely to be caused by dislocations; however, excellent agreement between the simulated and experimentally measured tunneling current magnitude and alignment bias is demonstrated. This analysis of the effects of scattering lifetimes, contact doping and growth quality on electron transport highlights critical optimization parameters for the development of III–nitride unipolar electronic and optoelectronic devices.
31 March 2014 in The Journal of Physical Chemistry Letters
6 January 2003 in IEEE Photonics Technology Letters
Intersubband electron scattering transport in terahertz GaAs-AlGaAs quantum cascade lasers is analyzed, using a full 13-level self-consistent rate equation model. The approach includes all relevant scattering mechanisms between injector-collector and active region states in the cascade structures. Employing an energy balance equation which includes the influence of both electron longitudinal optical phonon and electron-electron scattering, the method also enables evaluation of the average electron temperature of the nonequilibrium carrier distributions in the device. The electron temperature is found to give a strong influence on the output characteristics, particularly at very low temperatures. The threshold currents and electric field-current density characteristics are in very good agreement with experiment, implying that the model has a strong predictive capability.
28 March 2005 in Physical Review B
Time-resolved studies of the dynamics of intersubband transitions are reported in three different strain symmetrized multiple-quantum-well and quantum cascade structures in the far-infrared wavelength range (where the photon energy is less than the optical phonon energy), utilizing the FELIX free-electron laser. The calculated rates for optical and acoustic phonon scattering, alloy disorder scattering, and carrier-carrier scattering have been included in a self-consistent energy balance model of the transient far-infrared intersubband absorption, and show good agreement with our degenerate pump-probe spectroscopy measurements in which, after an initial rise time determined by the resolution of our measurement, we determine decay times ranging from depending on the design of the structure. In all three samples the lifetimes for the transition from the first light hole subband to the first heavy hole subband are found to be approximately constant in the temperature range .