Recurrent respiratory papillomatosis is a human papillomavirus-mediated condition characterised by the development of benign squamous papillomata of the respiratory tract. Malignant transformation of recurrent respiratory papillomatosis, while rare, carries a poor prognosis and there are limited data surrounding treatment options, particularly in inoperable disease. We present the case of a 64-year-old male who developed malignant airway obstruction secondary to primary tracheal squamous cell carcinoma in the setting of a 5-year history of recurrent laryngotracheal papillomatosis, requiring placement of tracheostomy while on veno-venous extracorporeal membranous oxygenation. He was managed with cisplatin-based definitive chemoradiotherapy and had a complete metabolic response on post-treatment positron emission tomography/computed tomography, and remains free of recurrent squamous cell carcinoma at 16 months following treatment. This case supports the use of combined chemoradiotherapy as a potential therapeutic option for patients with primary tracheal squamous cell carcinoma, and emphasises the challenges associated with the long-term management of recurrent respiratory papillomatosis.
Application of load-bearing osteosynthesis plates is the current gold-standard management for complex mandibular fractures. Traditionally, this has required a transcutaneous submandibular approach, carrying with it the risk of damage to the facial nerve and obvious extraoral scarring. The existing literature describes the use of computer-assisted design and manufacturing technology through external vendors to aid transoral mandibular reconstruction. However, the reliance on third-party manufacturers comes with significant drawbacks, notably increased financial costs and manufacturing delays. We describe our experience in using point-of-care three-dimensional-printed surgical models to aid with the application of mandibular reconstruction plates. Utilising a virtual three-dimensional reconstruction of the patient’s preoperative computed tomography facial bones, we fabricate a custom model of the patient’s mandible with the department’s in-house three-dimensional printer. Stock plates are subsequently pre-bent and adapted to the three-dimensional model, with plate and screw position marked and screw lengths measured with callipers. By using a custom three-dimensional-printed surgical model to pre-contour the plates, we are able to position stock reconstruction plates via a transoral approach. Moreover, our unit’s utilisation of in-house computer-assisted design and manufacturing software and hardware allows us deliver a same-day turnaround for both surgical planning and performing the operation. Patient-specific surgical planning guides can facilitate the safe and efficient transoral application of mandibular reconstruction plates. Moreover, the use of point-of-care computer-assisted design and manufacturing technology ensures timely and cost-effective manufacturing of the necessary biomodel.