23 May 2008 in Journal of the Optical Society of America B
For the first time, to the best of our knowledge, the existence of a surface wave at the one-dimensional photonic crystal (PC)–metal interface is verified experimentally. That surface mode is excited for both transverse electric and transverse magnetic polarizations in the frequency region where one of the bandgaps of the PC overlaps with the region below the plasma frequency of the metal in the frequency wave-vector space and is observed even under normal incidence from vacuum. For a fixed frequency its angular position is very sensitive to the thickness of the one-dimensional photonic-crystal layer adjacent to the metal.
18 May 2015 in Journal of Optics
1 April 1994 in Journal of the Optical Society of America B
I use the Rayleigh-Fano theory to calculate the optical response of a stack of N thin films with rough interfaces, defined by arbitrary periodic functions of the same period, bounded by two semi-infinite media. Each medium is assumed to be homogeneous, isotropic, local, and linear and characterized by a frequency-dependent complex dielectric constant. I derive two matrix equations that relate the reflected and the transmitted fields to the incident wave. These matrices can be calculated in a recursive way. The solution involves Fourier coefficients of functions that are dependent on the roughness profiles. This treatment is valid for both TM(p) or TE(s) polarizations. I apply this formulation to some particular cases.
15 November 2003 in Optics Communications
24 June 2014 in Journal of the Optical Society of America A
We theoretically studied the influence of an infinite set of waveguides on the evanescent field of Bloch waves at the surface of a one-dimensional photonic crystal (PC) excited by a TE Gaussian beam undergoing total internal reflection. The set of waveguides is regarded as a periodic inhomogeneous medium with period . Numerical results are presented for the case in which is greater than , which is the wavelength used to excite the surface mode. When the waveguide tip is very close to the surface of the PC, a fraction of the surface wave is reflected by the tip, producing an interference pattern that can be observed in the near field. In this case, the system simulates scanning tunneling optical microscopy in 2D geometry, and an image of the field distribution of the surface mode is obtained by quantifying the flux energy throughout the waveguide.
11 May 2018 in Optics Letters
We calculated the out-of-plane band structure of a two-dimensional dispersive photonic crystal (PC). To achieve this goal, the plane wave expansion method was implemented in conjunction with a numerical algorithm, the dispersive photonic crystal iterative method. The PC is an array of circular cross-sectional dispersive MgO Lorentz single-pole rods in a square lattice. The frequency bands are calculated starting at as a function of the oblique component of the wave vector. For the lowest frequencies, it was found that the modes bend drastically to the horizon as the dielectric constant is increased to a very positive value. For frequencies above the longitudinal optical phonon circular frequency, where has very low positive values, the expected degeneration occurs in the transparency window, and a line of modes behaves close to the line of light.