7 October 2020 in Plasma Chemistry and Plasma Processing
A time-dependent, spatially one-dimensional fluid-Poisson model is applied to analyze the impact of small amounts of tetramethylsilane (TMS) as precursor on the discharge characteristics of an atmospheric-pressure dielectric barrier discharge (DBD) in argon. Based on an established reaction kinetics for argon, it includes a plasma chemistry for TMS, which is validated by measurements of the ignition voltage at the frequency $$f =86.2\, {\hbox{kHz}}$$ for TMS amounts of up to 200 ppm. Details of both a reduced Ar-TMS reaction kinetics scheme and an extended plasma-chemistry model involving about 60 species and 580 reactions related to TMS are given. It is found that good agreement between measured and calculated data can be obtained, when assuming that 25% of the reactions of TMS with excited argon atoms with a rate coefficient of $$3.0 \times 10^{-16}\, {\hbox{m}^3/\hbox{s}}$$ lead to the production of electrons due to Penning ionization. Modeling results for an applied voltage $${U}_{{\mathrm{a}},0} = 4\, {\hbox{kV}}$$ show that TMS is depleted during the residence time of the plasma in the DBD, where the percentage consumption of TMS decreases with increasing TMS fraction because only a finite number of excited argon species is available to dissociate and/or ionize the precursor via energy transfer. Main species resulting from that TMS depletion are presented and discussed. In particular, the analysis clearly indicates that trimethylsilyl cations can be considered to be mainly responsible for the film formation.
21 November 2023 in Surface and Coatings Technology
23 March 2024 in Advanced Engineering Materials
The binary system Mo–Si is reassessed based on previously reported findings that the phase shows a deficiency in Si and to take into account experimental data on the heat capacities of the Mo silicides. The last aspect in particular has been neglected in previous assessments of the system. Experimental studies are carried out which confirm that the phase is deficient in Si in every alloy analyzed, with an average Si content of 23 at%. The thermodynamic description of this phase is adjusted accordingly and the parameters of the system are optimized. Two alternative possible descriptions are presented for the phase . It is shown that the calculated binary phase diagram agrees well with experimental data, like liquidus and solidus temperatures as well as homogeneity ranges of the phases, where applicable, for both datasets. Likewise, thermophysical data like enthalpies of the formation of the silicides are adequately described.
27 July 2023 in Acta Materialia