6 March 2018 in Japanese Journal of Applied Physics
We report on the electrical characterization of Si-ion implanted AlN layers and the first demonstration of metal–semiconductor field-effect transistors (MESFETs) with an ion-implanted AlN channel. The ion-implanted AlN layers with Si dose of 5 × 10 14 cm −2 exhibit n-type characteristics after thermal annealing at 1230 °C. The ion-implanted AlN MESFETs provide good drain current saturation and stable pinch-off operation even at 250 °C. The off-state breakdown voltage is 2370 V for drain-to-gate spacing of 25 µm. These results show the great potential of AlN-channel transistors for high-temperature and high-power applications.
6 November 2019 in Japanese Journal of Applied Physics
We investigated dry and wet etchings of β-Ga2O3 and fabricated vertical Schottky barrier diodes (SBDs) with mesa termination using the optimal etching condition. Using an inductively-coupled plasma reactive-ion etching with a nickel-hard mask, a β-Ga2O3 (010) mesa structure with a smooth sidewall is obtained at an etching rate of 77 nm min−1 in BCl3/Cl2 mixture gas. By immersing β-Ga2O3 (001) vertical SBDs with mesa termination in hot phosphoric-acid solution, the specific on resistance and ideality factor of the SBDs are reduced to 0.91 mΩcm2 and 1.03, respectively. Current density at reverse bias is in good agreement with thermionic field emission model.
4 March 2019 in Japanese Journal of Applied Physics
This paper demonstrates a modulation-doped fisseld-effect transistor (MODFET) and a metal-semiconductor field-effect transistor (MESFET) using β -(AlGa) 2 O 3 (010). Ohmic contacts on Sn-doped (Al 0.15 Ga 0.85 ) 2 O 3 exhibit a fairly linear behavior, which has a specific contact resistivity and sheet resistance of 9 × 10 −5 Ω cm 2 and 75 kΩ/□, respectively. The MODFET with Sn-doped (Al 0.08 Ga 0.92 ) 2 O 3 barrier layer showed a breakdown voltage of 610 V for gate-drain spacing ( L gd ) of 8 μ m, while the (Al 0.16 Ga 0.85 ) 2 O 3 -channel MESFET exhibited a breakdown voltage of 940 V for L gd of 20 μ m. These results show the great potential of (AlGa) 2 O 3 transistors for high-power applications.
1 October 2023 in AIP Advances
In this work, p-type cuprous oxide (Cu2O) films grown on beta gallium oxide (β-Ga2O3) substrates by magnetron sputtering were reported. The resulting vertical Cu2O/β-Ga2O3 heterojunction p–n diodes demonstrated superior performance compared to devices fabricated with polycrystalline Cu2O thin films. Meanwhile, analysis of the discrepancies between the built-in potential and turn-on voltage revealed diverse carrier transport mechanisms in the fabricated devices. Numerical fitting of the forward J–V characteristics further discerned that distinct carrier transport mechanisms dominated under various bias voltages or temperature conditions. At 300 K, trap-assisted tunneling dominates the regime because of the presence of defects in β-Ga2O3 or Cu2O. While the bias voltage is low, the polycrystalline nature of the films formed at room temperature leads to the prevalence of grain boundaries as the primary source of interface-type defects at the Cu2O/β-Ga2O3 interface. Consequently, the dominant mechanism governing carrier transport is interface recombination. As the temperature increases, however, thermionic emission becomes more important. This study presents an opportunity for further investigation into the epitaxial growth of Cu2O and provides insights into the carrier transport mechanism of β-Ga2O3-based heterojunctions.
25 September 2018 in Applied Physics Express
1 June 2023 in Applied Physics Express
AlN with a large bandgap energy is one of the most attractive materials for high-temperature applications. However, performance of AlN devices at high temperatures has been limited by technical problems with electrical characterization systems. Here, we show that Schottky-barrier diodes (SBDs) and metal-semiconductor field-effect transistors with Si-implanted AlN channels can operate at 1100 K and 1000 K, respectively. The breakdown voltage and barrier height of the AlN SBD were 610 V and 3.5 eV, respectively. We found that the high barrier height and thermal stability of the Ni contact on AlN greatly contributed to high-temperature operation of the devices.