Ternary coatings Fe-Co-W with an iron content of 40–55 at.%, cobalt 39–44 at.%, and tungsten 4–12 at.% and Fe-Co-Mo with an iron content of 40–55 at.%, cobalt 39–44 at.%, and tungsten 4–12 at.% were obtained by galvanostatic and pulse electrolysis on the mild steel substrate from iron(III) citrate-based electrolyte. The influence of electrolysis mode and parameters on composition of deposited alloys was studied. The competing reduction of iron and tungsten in Fe-Co-W coatings as well as the competitive deposition of iron and cobalt in Fe-Co-Mo coatings at various current densities were defined. Simultaneously, the alloy enrichment with molybdenum is more marked at a pulse mode. Atomic force microscope analysis of the Fe-Co-W alloy coating morphology and surface topography indicates their globular structure with spherical grains in the range of 2.5–3.5 μm. The surface of Fe-Co-Mo is characterized by parts of a globular structure with an average conglomerate size of 0.3–0.5 μm and singly located cone-shaped hills with a base diameter of 3 μm. Sites with a developed surface were detected within the same scan area which topography is identical to the crystal lattice of cobalt with the crystalline conglomerate sizes in the range of 0.2–1.75 μm.
1 June 2017 in IOP Conference Series: Materials Science and Engineering
Coatings Fe-Co-Mo with a composition of 47 at.% iron, 28 at.% Cobalt and 25 at.% Molybdenum were deposited from citrate electrolyte using pulse electrolysis mode. Scanning electron and atomic force microscopy have established the surface morphology and topography. It was identified the parts with a globular structure which have an average size of 0.2-0.5μm and singly located sharp grains. Within the same scan area sites with developed surface were detected the topography of which is identical to the crystal structure of cobalt with the crystallites size of 0.2-1.75μm. The parameters Ra and Rq for parts with different morphology as well as average characteristics of coatings demonstrated the low roughness of the surface. It is found that the coercive force of Fe-Co-Mo films is 7-10 Oe, which allow us to classify the Fe-Co-Mo coatings as soft magnetic materials.
1 December 2015 in Russian Journal of Applied Chemistry
Finely crystalline cobalt–molybdenum–tungsten coatings were deposited in the nonsteady-state mode from a polyligand citrate-pyrophosphate electrolyte at a concentration ratio of the alloy-forming...
1 March 2014 in Russian Journal of Applied Chemistry
Specific features of the electrodeposition of iron-molybdenum coatings from a citrate electrolyte based on iron(III) sulfate and sodium molybdate in dc and unipolar pulsed modes were studied. It was demonstrated that bright compact coatings with varied content of molybdenum can be produced by varying the relative concentrations of salts of the alloy-forming components and the solution pH. The current density ranges providing the high efficiency of the galvanostastic electrolysis were determined and it was shown that using the pulsed mode makes smaller the amount of nonmetallic impurities in a coating, diminishes its roughness and leads to formation of surface layers with a more uniform composition, The iron-molybdenum coatings exhibit a high corrosion resistance in corrosive media and physicomechanical properties improved as compared with the base metal, which makes it possible to recommend these coatings for protection from corrosive-mechanical disintegration and restoration of the surface of worn articles.