4 December 2019 in npj Materials Degradation
The failure mechanism of model organic coatings from Mg alloy surfaces is characterised by a combination in-situ scanning Kelvin probe analysis and time lapse photography. Initiation of underfilm corrosion by application of group I chloride salts to a penetrative coating defect produces an apparent cathodic-driven coating delamination, where the disbondment distance increases linearly with time at high relative humidity, although filiform corrosion (FFC) is also observed in the vicinity of the defect. The disbondment process occurs both in the presence and absence of oxygen, indicating that hydrogen evolution comprises the predominant underfilm cathodic reaction. Post-corrosion elemental analysis of the delaminated region shows an abundance of group I cation, but no chloride. When magnesium chloride or HCl are used to initiate corrosion, then only FFC is produced. The mechanism is discussed in terms of net anodic dissolution at the defect coupled with underfilm cathodic hydrogen evolution, producing organic coating disbondment under conditions where cations are able to transport ionic current within a zone of increased pH.
21 August 2020 in Corrosion
The localized corrosion behavior of E717 magnesium alloy immersed in chloride-containing electrolyte is investigated using an in situ scanning vibrating electrode technique (SVET) coupled with time-lapse imaging. It is shown that initiation of localized corrosion in chloride-containing electrolyte is characterized by the appearance of discrete local anodes, corresponding with the leading edges of dark, filiform-like features, which combine with time to produce a mobile anodic front. The size and growth rate of these features are highly dependent on the chloride ion concentration of the electrolyte. SVET-derived current density maps reveal that the corroded surface left behind the anodic front is cathodically activated, where cathodic current density values progressively decline with increasing distance away from the anodic leading edge. The intensity of localized anodes is highly dependent on the chloride ion concentration, where progressively higher local anodic current density values are observed with increasing chloride ion concentration along with progressively higher rates of volumetrically determined hydrogen evolution. Breakdown potential, measured using time-dependent free corrosion potential transients and potentiodynamic polarization at neutral and elevated pH, respectively, is shown to vary with the logarithm of chloride ion concentration, and the time for localized corrosion initiation is progressively increased with decreasing chloride concentration. From the combination of results that are presented herein, the underlying reasons for the influence of chloride ion concentration on the localized corrosion characteristics of E717 alloy will be discussed.
1 January 2022 in SSRN Electronic Journal
The filiform corrosion (FFC) of organic coated magnesium alloys is investigated using in-situ scanning Kelvin probe and time-lapse photography. FFC is initiated by injecting MgCl2, HCl and FeCl2 into a coating defect and the FFC propagation rates, are shown to increase as a function of log[Cl-], remain unaffected by the absence of oxygen but strongly dependent on relative humidity. Post-corrosion surface analysis shows chloride abundance near the filament leading edge and evidence of sequestration within corroded regions behind. The FFC mechanism is consistent with chloride-induced anodic dissolution at the front coupling with water reduction on a cathodically-activated corroded surface behind.