13 January 2024 in International Journal of Fatigue
1 September 2019 in Colloids and Surfaces A: Physicochemical and Engineering Aspects
21 March 2024 in Surfaces and Interfaces
5 April 2016 in SAE International Journal of Advances and Current Practices in Mobility
The reduction of engine weight is today a widely used and effective approach to increasing automotive fuel efficiency . However, the realization of weight savings in the engine can increase deformation of the crankshaft and cylinder block, resulting in fretting fatigue of the contact surfaces of the bearing caps and the cylinder block. Although researchers have identified the mechanism of fretting fatigue on the cylinder block, as yet there is no effective method of addressing the issue in the development stage. The research discussed in this paper applied quality engineering methods to investigate a variety of factors considered to influence fretting fatigue in unit test equipment. The results of the study indicated a good correlation between unit tests and actual engine tests. The paper will also discuss analytic methods for obtaining basic materials data, and methods of prediction of fretting fatigue at an early design stage.
5 April 2016 in SAE International Journal of Engines
The independent bearing cap is a cylinder block bearing structure that has high mass reduction effects. In general, this structure has low fastening stiffness compared to the rudder block structure. Furthermore, when using combination of different materials small sliding occurs at the mating surface, and fretting fatigue sometimes occurs at lower area than the material strength limit. Fretting fatigue was previously predicted using CAE, but there were issues with establishing a correlation with the actual engine under complex conditions, and the judgment criteria were not clear, so accurate prediction was a challenge. This paper reports on a new CAE-based prediction method to predict the fretting damage occurring on the bearing cap mating surface in an aluminum material cylinder block. First of all, condition a fretting fatigue test was performed with test pieces, and identification of CAE was performed for the strain and sliding amount. In addition, the fatigue life results obtained by the test-piece test were used to construct a fretting fatigue limit line for the strain and sliding amount of the CAE results. Next, identification was performed with an excitation rig test that simulates an actual engine operating condition, and the CAE boundary conditions were determined. The strength predicted by CAE and the fretting result by the excitation rig test were correlated well. It showed the validity of the newly constructed CAE method. Finally, fretting damage under the actual engine durability test was also predicted, and the results were confirmed to also exhibit good correlation.
22 October 2026 in SSRN Electronic Journal
An orthogonal experimental design was combined with electrochemical measurements (OCP and potentiodynamic polarization), microstructural characterization (SEM/EDS and XRD), and COMSOL finite element simulations. The combined effects of applied tensile stress, scratches in the anodic oxide film, and NaCl concentration on corrosion at defects in anodized 7A04-T6 aluminium alloy were systematically investigated. Electrochemical corrosion at oxide film defects was governed by the coupled effects of stress, defects and NaCl concentration. Their effects on the corrosion rate ranked as follows: applied stress > scratch size > NaCl concentration. The defects produced a distinct low-stress region outside the scratch and stress concentrations along its inner edges. Galvanic coupling between these regions accelerated anodic dissolution of the substrate in the stress-concentrated region. Large scratches (6 mm) further amplified local galvanic effects, whereas increasing NaCl concentration initially promoted and subsequently inhibited corrosion. Under the combined conditions of a 6 mm scratch, a tensile stress of 50% of the yield strength, and 3.5% NaCl, simulations yielded a characteristic inner-edge equivalent stress of 559 MPa, distinct from the highly localized maximum of 1340 MPa near a sharp geometric discontinuity. The anodic equilibrium potential at the inner edge was -0.758 V, compared with -0.747 V at the low-stress outer edge. These results suggest that local electrochemical differences promote preferential dissolution in stress-concentrated regions and may contribute to further corrosion damage.