18 July 2022 in IEEE Transactions on Industrial Electronics
This article presents and validates a method for early estimation of the high-frequency impedance response for a real permanent magnet synchronous machine. The main contribution of this work lies in the simplicity of the data required to tackle the prediction, which do not require any experimental tuning or 3-D simulations. The required inputs for the method are the 2-D cross section of the machine and the material characteristics of the conductors, insulation, and iron laminations. An approach using the finite element method coupled with a circuit simulator is utilized to obtain the machine common-mode and differential-mode impedances over a broad frequency range. Experimental measurements are performed up to the resonance band to validate the methodology. In addition, the influence of the machine rotor and housing on the impedance curves is experimentally assessed. A machine with concentrated winding is used as a case study machine to test the model.
4 April 2022 in IEEE Transactions on Transportation Electrification
This article proposes a data-driven structural modeling approach for electrical machine airborne vibration that can be used both in the design stage for fast optimization routines and in system-level simulations. This method is able to capture both in-plane and out-of-plane modal behavior along with local effects, such as tooth bending. The model relies on fitting unitary force-shape responses to transfer function models using a zero-pole representation. These frequency response functions are obtained from applying the vibration synthesis process to a series of finite-element (FE) stator models that have material properties updated using the experimental modal analysis. The obtained zeros and poles are used to construct three lookup table models with their accuracy varying between the three of them with the number of samples used in the data generation process. The accuracy of these models is validated at the unitary force-shape response level using four stator FE model samples. Also, at the run-up vibration spectrogram level, the models are validated, with good results, using radial and tangential force excitation obtained from an updated electromagnetic FE model of an interior permanent magnet (PM) synchronous machine designed for electric power steering. The computational cost compared to the standard FE vibration synthesis method is shown.
15 August 2018 in IEEE Transactions on Energy Conversion
This paper provides electric machine designers with a stator core lamination attachment method that improves the noise and vibration performances of the machine by reducing resonance effects of critical modes. The proposed method uses welding or gluing technologies to attach the laminations together. The connections are distributed such that the core stiffness is axially, and more importantly transversally asymmetric. The novel technique leads to dampening of targeted modes and is validated experimentally. The results show great modal damping improvements up to 7 times the initial value from regular cores and vibration levels reduced by 9 dB.
16 August 2021 in IEEE Access
This paper presents a current shaping method for torque ripple and mean air-gap radial force-shape harmonics reduction, under minimum Joule losses, used for air-born and structure-born vibration reduction in 3-phase PMSM electric drives. The main source for structure-born noise in electric powertrains is the torque ripple, while the main source for air-born noise are the radial air-gap forces. The proposed method uses a Fourier-decomposed LUT model obtained from updating the 2D electromagnetic FE model using test-bench results. Modal testing is used to update the structural model, and the vibration response on the machine full RPM range is determined using the vibration-synthesis method. The proposed current shaping algorithm is deterministic and can be used on any topology of 3-phase PMSMs. The torque and mean air-gap force harmonics that are intended for reduction can be arbitrary selected and their minimization can be fully completed if the maximum current and voltage constraint are respected. On the machine under test, vibration reduction is accomplished, especially for the mechanical orders that interact with the second mode-shape.